Re: [PATCH v3 1/2] dt-bindings: gnss: u-blox: add "safeboot-gpios" binding

[Johan Hovold <johan@kernel.org>]

On Thu, Sep 11, 2025 at 02:58:28PM +0200, Alejandro Enrique via B4 Relay wrote:
> From: Alejandro Enrique <alejandroe1@geotab.com>
> 
> U-Blox 8/M8/M9 chip have a pin to start it in safeboot mode, to be
> used to recover from situations where the flash content has become
> corrupted and needs to be restored. Introduce a binding to support
> this safeboot pin.
> 
> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> Signed-off-by: Alejandro Enrique <alejandroe1@geotab.com>
 
> +allOf:
> +  - $ref: gnss-common.yaml#
> +  - $ref: /schemas/serial/serial-peripheral-props.yaml#
> +  - if:
> +      properties:
> +        compatible:
> +          contains:
> +            const: u-blox,neo-6m
> +    then:
> +      properties:
> +        safeboot-gpios: false
> +

I don't think it's worth adding conditionals like this for an optional
gpio as it just makes the binding harder to read for no good reason (cf.
a dt checker can't verify that you're not using the wrong host pin in
your identifier either).

So I used your v1 without this (and dropped Krzysztof's tag).

>  unevaluatedProperties: false
>  
>  examples:
> @@ -65,5 +76,6 @@ examples:
>              v-bckp-supply = <&gnss_v_bckp_reg>;
>              vcc-supply = <&gnss_vcc_reg>;
>              reset-gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
> +            safeboot-gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
>          };
>      };

Johan