Re: [PATCH v1 06/11] arm64: dts: freescale: imx8mm-var-som: Update WiFi/BT configuration

[Stefano Radaelli <stefano.radaelli21@gmail.com>]

Hello everyone,

On Wed, Feb 18, 2026 at 06:18:16PM +0100, Stefano Radaelli wrote:
> Hi Frank,
> 
> On Wed, Feb 18, 2026 at 11:35:23AM -0500, Frank Li wrote:
> > On Tue, Feb 17, 2026 at 08:42:19PM +0100, Stefano Radaelli wrote:
> > > Hi Fabio!
> > >
> > > On Tue, Feb 17, 2026 at 03:59:33PM -0300, Fabio Estevam wrote:
> > > >
> > > > What about users who still have boards with the Broadcom Wi-Fi chip?
> > > >
> > > > Will Wifi on the old boards stop working?
> > >
> > > The Broadcom-based WiFi module was used on earlier revisions of the
> > > VAR-SOM-MX8MM. That hardware revision is no longer in production and
> > > is not available for new orders. All currently manufactured and shipped
> > > VAR-SOM-MX8MM modules integrate the NXP IW61x instead.
> > 
> > This common problem, we met similar case. After replace new compenent, it
> > should be new boards, or new revision.
> > 
> > I don't suggest directly replace it to broken old one. You can create dt
> > overlay files for new boards.
> > 
> > Krzysztof Kozlowski:
> > 	how about other vendor handle similar case? Any guide line for
> > that?
> > 
> > Frank
> > 
> 
> Thanks for the feedback!
> 
> We understand the concern about potential regressions on older SOM
> revisions. However, since the wireless module is soldered on the SOM
> and not configurable, we are aligning the upstream device tree with
> the hardware revision that is currently in production.
> 
> This change also aligns the i.MX8MM VAR-SOM with other VAR-SOM
> platforms already present in mainline (e.g. i.MX8MP, i.MX93), which
> use the IW61x wireless module as well. The intention is to keep the
> VAR-SOM family consistent in mainline with the hardware that is
> actively produced.
> 
> If there is a strong requirement to preserve an explicit description
> of the older Broadcom-based revision in mainline, we can evaluate
> adding a separate description.
> 
> Best regards,
> Stefano

Do you have any update about this topic?

Thank you a lot,
Best Regards,
Stefano