Re: [PATCH v1 2/2] iio: dac: ad5504: use adi,output-range-volts for scale calculation

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Sun, Feb 15, 2026 at 06:05:38PM +0000, Jonathan Cameron wrote:
> On Thu, 12 Feb 2026 22:15:55 +0200
> Andy Shevchenko <andriy.shevchenko@intel.com> wrote:
> > On Thu, Feb 12, 2026 at 07:19:55PM +0100, Taha Ed-Dafili wrote:

...

> > > +	ret = device_property_read_u32(&spi->dev, "adi,output-range-volts", &val);  
> > 
> > You can pack this into 80 limit with help of
> > 
> > 	struct device *dev = &spi->dev;
> > 
> > being defined in the top of the function.
> > 
> > > +	if (ret)
> > > +		val = 60;  
> > 
> > Also this seems an optional, so
> > 
> > 	val = 60;
> > 	device_property_read_u32(dev, "adi,output-range-volts", &val);
> > 
> > would be enough.
> > 
> > ...
> > 
> > > +	if (val == 60)
> > > +		st->vref_mv = 60000;  
> > 
> > 60 * MILLI;
> 
> val * MILLI
> given it only takes the values 30 and 60 I think. If you want to protect
> against other values, then check it explicitly rather than everything than
> isn't 60 being assumed to be 30.

With comment on DT in mind I think this multiplication will gone
(as IIUC the DT units is microvolts or so).

> > > +	else
> > > +		st->vref_mv = 30000;  
> > 
> > 30 * MILLI;
> > 
> > Needs units.h.

-- 
With Best Regards,
Andy Shevchenko