Re: [PATCH v6 3/5] i2c: davinci: calculate bus freq from Hz instead of kHz

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Mon, Feb 16, 2026 at 01:38:15PM +0100, Marcus Folkesson wrote:
> The bus frequency is unnecessarily converted between Hz and kHz in
> several places.
> This is probably an old legacy from the old times (pre-devicetrees)
> when the davinci_i2c_platform_data took the bus_freq in kHz.
> 
> Stick to Hz.

...

>  	/*
>  	 * According to I2C-BUS Spec 2.1, in FAST-MODE LOW period should be at
>  	 * least 1.3uS, which is not the case with 50% duty cycle. Driving HIGH
>  	 * to LOW ratio as 1 to 2 is more safe.
>  	 */
> -	if (dev->bus_freq > 100)
> +	if (dev->bus_freq_hz > 100000)

The 100000 has a definition in i2c.h....

>  		clkl = (clk << 1) / 3;
>  	else
>  		clkl = (clk >> 1);

...

>  	r = device_property_read_u32(&pdev->dev, "clock-frequency", &prop);

(Why not using i2c timings? The I²C core has an API to parse firmware properties.)

>  	if (r)
> -		prop = DAVINCI_I2C_DEFAULT_BUS_FREQ;
> +		prop = I2C_MAX_STANDARD_MODE_FREQ;

...like this one.

-- 
With Best Regards,
Andy Shevchenko