Re: [PATCH 6/6] staging: sm750fb: sm750_sw_i2c_init: return -EINVAL for invalid GPIO

[Dan Carpenter <dan.carpenter@linaro.org>]

On Wed, Mar 04, 2026 at 11:05:29PM +0530, Soham Kute wrote:
> Return -EINVAL instead of -1 when the GPIO pin number is out of
> range. The caller ignores the return value.
> 
> Signed-off-by: Soham Kute <officialsohamkute@gmail.com>
> ---
>  drivers/staging/sm750fb/ddk750_swi2c.c | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/staging/sm750fb/ddk750_swi2c.c b/drivers/staging/sm750fb/ddk750_swi2c.c
> index c73943341f66..46599be8d6b9 100644
> --- a/drivers/staging/sm750fb/ddk750_swi2c.c
> +++ b/drivers/staging/sm750fb/ddk750_swi2c.c
> @@ -344,7 +344,7 @@ static unsigned char sw_i2c_read_byte(unsigned char ack)
>   *      data_gpio     - The GPIO pin to be used as i2c SDA
>   *
>   * Return Value:
> - *      -1   - Fail to initialize the i2c
> + *      -EINVAL - Fail to initialize the i2c
>   *       0   - Success
>   */
>  static long sm750le_i2c_init(unsigned char clk_gpio, unsigned char data_gpio)

This part needs to be done in the patch that changes
sw_i2c_read_byte().

regards,
dan carpenter

> @@ -382,7 +382,7 @@ static long sm750le_i2c_init(unsigned char clk_gpio, unsigned char data_gpio)
>   *      data_gpio     - The GPIO pin to be used as i2c SDA
>   *
>   * Return Value:
> - *      -1   - Fail to initialize the i2c
> + *      -EINVAL - Fail to initialize the i2c
>   *       0   - Success
>   */
>  long sm750_sw_i2c_init(unsigned char clk_gpio, unsigned char data_gpio)
> @@ -394,7 +394,7 @@ long sm750_sw_i2c_init(unsigned char clk_gpio, unsigned char data_gpio)
>  	 * range is only from [0..63]
>  	 */
>  	if ((clk_gpio > 31) || (data_gpio > 31))
> -		return -1;
> +		return -EINVAL;
>  
>  	if (sm750_get_chip_type() == SM750LE)
>  		return sm750le_i2c_init(clk_gpio, data_gpio);
> -- 
> 2.34.1
>