Re: [PATCH net-next 10/12] net: stmmac: tc956x: add TC956x/QPS615 support

[Daniel Thompson <daniel@riscstar.com>]

On Wed, May 06, 2026 at 04:19:54PM +0200, Andrew Lunn wrote:
> On Wed, May 06, 2026 at 08:59:01PM +0800, Xilin Wu wrote:
> > On 5/1/2026 11:54 PM, Alex Elder wrote:
> > > +	/* AXI Configuration */
> > > +	axi = &td->axi;
> > > +	axi->axi_lpi_en = 1;
> > > +	axi->axi_wr_osr_lmt = 31;
> > > +	axi->axi_rd_osr_lmt = 31;
> > > +	/* All sizes (2^2..2^8) are supported */
> > > +	axi->axi_blen_regval = DMA_AXI_BLEN_MASK;
> > > +	plat->axi = axi;
> > > +
> > > +	plat->mac_port_sel_speed = speed;
> > > +	plat->flags = STMMAC_FLAG_MULTI_MSI_EN | STMMAC_FLAG_TSO_EN;
> >
> > I got WoL working only after adding STMMAC_FLAG_USE_PHY_WOL here. I guess
> > it's required, since the driver clocks down the MAC/PMA/XPCS in its suspend
> > hook?
>
> Nice to see somebody testing WoL.

Absolutely!

We recently stripped out the (obviously broken and partially ported)
WoL support we had in tc956x-pci.c. We planned to bring it back later.
Hadn't realized it could be so easy.


> In your testing, is it the PHY doing the WoL, or the MAC? I assume
> PHY.
>
> If i remember the DT correctly, the PHY interrupt is connected to a
> SoC GPIO, not a GPIO of this chip.

On RB3Gen2 (and I think also the QPS615 reference design) the phy
interrupt is routed twice. It is connected both to the TC9564 GPIO
block and to the host SoC.


> So for your board, it is the SoCs
> GPIO controllers ability to perform the wake which is
> important. However, where the PHY interrupt is connected is a board
> design issue. Could the PHY interrupt be connected to the chip? Would
> the chip be able to wake the system? Should STMMAC_FLAG_USE_PHY_WOL be
> conditional?

I couldn't think of any reason to use the TC9564 GPIO block for the
interrupts on RB3gen2 so I left it unused and the DT describes the SoC
routing only.

However if TC9564 were to be mounted on a real PCIe card then we'd have
to use the TC9564 GPIO instead and would have to leave enough of the
TC9564 enabled to handle the interrupt (and also to load a firmware to
catch the interrupt and drive the PCI wake up signal).

However such systems would need extensions to the current driver. We
have done all we can to make it possible to add those extensions in the
future but we would not be able to test them: not only do would a real
PCIe card need extra driver features to play nice with ACPI but the
card would also need an I2C EEPROM. We don't have that EEPROM on
RB3gen2 (and again, we'd need firmware to read it).

TL;DR - there are conceivable (and sane) hardware designs where the
interrupt goes only to the TC9564 GPIO, but they are too different to
RB3gen2 (and related SBC designs) for them to be supported before
they exist!


Daniel.