Re: [PATCH] riscv: dts: starfive: jh7110-common: Use named definition for mmc1 card detect

[E Shattow <e@freeshell.de>]

Hi, Hal

On 12/16/24 18:02, Hal Feng wrote:
>> On 17.12.24 04:13, Conor Dooley wrote:
>> On Mon, 09 Dec 2024 20:06:46 -0800, E Shattow wrote:
>>> Use named definition for mmc1 card detect GPIO instead of numeric literal.
>>>
>>>
>>
>> Applied to riscv-dt-for-next, thanks!
>>
>> [1/1] riscv: dts: starfive: jh7110-common: Use named definition for mmc1
>> card detect
>>        https://git.kernel.org/conor/c/c96f15d79172
> 
> No, here "41" means the GPIO number, but GPI_SYS_SDIO1_CD means the
> multiplexed function and should be used by pinctrl pinmux not gpio subsystem.
> Although GPI-SYS_SDIO1_CD is numerically the same as 41.
> 
> Best regards,
> Hal

You're right, Hal. I'm confused trying to make sense of this.

 From dts/upstream/src/riscv/starfive/jh7110-pinfunc.h:

"gpio nr:  gpio number, 0 - 63"

And yet in dts/upstream/src/riscv/starfive/jh7110-common.dtsi there's:

 >                        pinmux = <PINMUX(64, 0)>,
 >                                 <PINMUX(65, 0)>,
 >                                 <PINMUX(66, 0)>,
 >                                 <PINMUX(67, 0)>,
 >                                 <PINMUX(68, 0)>,
 >                                 <PINMUX(69, 0)>,
 >                                 <PINMUX(70, 0)>,
 >                                 <PINMUX(71, 0)>,
 >                                 <PINMUX(72, 0)>,
 >                                 <PINMUX(73, 0)>;


Loosely on the subject of MMC interface and GPIO numbering, what is the 
above code doing? These are not GPIO numbers 0-63 so what is this?

I'm trying to understand this so I can write the Mars CM (-Lite) dts.

Conor, and Hal: sorry for the mistake there.

-E