Re: [PATCH] staging: rtl8712: remove the condition with no effect

[Saurav Girepunje <saurav.girepunje@gmail.com>]

On 28/10/21 4:56 pm, Pavel Skripkin wrote:
> On 10/28/21 07:31, Saurav Girepunje wrote:
>> Remove the if condition check and else code section in
>> query_rx_phy_status(). As variable cck_highpwr is assign a value of '0'
>> after this assignment, if condition check !cck_highpwr is always
>> going to be true. So remove the if condition check as well as else
>> section which will be never true.
>>
>> After removing the if condition there is no use of local variable
>> cck_highpwr. Remove the local variable cck_highpwr.
>>
>> Signed-off-by: Saurav Girepunje <saurav.girepunje@gmail.com>
>> ---
> 
> [code snip]
> 
>> +        report = pcck_buf->cck_agc_rpt & 0xc0;
>> +        report >>= 6;
>> +        switch (report) {
>> +        /* Modify the RF RNA gain value to -40, -20,
>> +         * -2, 14 by Jenyu's suggestion
>> +         * Note: different RF with the different
>> +         * RNA gain.
>> +         */
>> +        case 0x3:
>> +            rx_pwr_all = -40 - (pcck_buf->cck_agc_rpt &
>> +                     0x3e);
> 
> You can move "0x3e);" part on previous line, since it will fit even 80 characters boundary. It will improve readability, IMO
> 
> Same below.
> 
Yes, This is also can be done on same patch.
Thanks for review Pavel
>> +            break;
>> +        case 0x2:
>> +            rx_pwr_all = -20 - (pcck_buf->cck_agc_rpt &
>> +                     0x3e);
>> +            break;
>> +        case 0x1:
>> +            rx_pwr_all = -2 - (pcck_buf->cck_agc_rpt &
>> +                     0x3e);
>> +            break;
>> +        case 0x0:
>> +            rx_pwr_all = 14 - (pcck_buf->cck_agc_rpt &
>> +                     0x3e);
>> +            break;
>>           }
>> +
> 
> 
> 
> With regards,
> Pavel Skripkin

Regards,
Saurav