Re: [PATCH v4 2/6] i3c: mipi-i3c-hci: Read HC_CONTROL_PIO_MODE only after i3c hci v1.1

[Jarkko Nikula <jarkko.nikula@linux.intel.com>]

Hi

On 8/21/24 4:35 PM, Shyam Sundar S K wrote:
> The HC_CONTROL_PIO_MODE bit was introduced in the HC_CONTROL register
> starting from version 1.1. Therefore, checking the HC_CONTROL_PIO_MODE bit
> on hardware that adheres to older specification revisions (i.e., versions
> earlier than 1.1) is incorrect. To address this, add an additional check
> to read the HCI version before attempting to read the HC_CONTROL_PIO_MODE
> status.
> 
> Signed-off-by: Shyam Sundar S K <Shyam-sundar.S-k@amd.com>
> ---
>   drivers/i3c/master/mipi-i3c-hci/core.c | 5 +++--
>   1 file changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/i3c/master/mipi-i3c-hci/core.c b/drivers/i3c/master/mipi-i3c-hci/core.c
> index b02fbd7882f8..d1952a5619d4 100644
> --- a/drivers/i3c/master/mipi-i3c-hci/core.c
> +++ b/drivers/i3c/master/mipi-i3c-hci/core.c
> @@ -33,6 +33,7 @@
>   #define reg_clear(r, v)		reg_write(r, reg_read(r) & ~(v))
>   
>   #define HCI_VERSION			0x00	/* HCI Version (in BCD) */
> +#define HCI_VERSION_V1			0x100   /* MIPI HCI Version number v1.0 */
>   
>   #define HC_CONTROL			0x04
>   #define HC_CONTROL_BUS_ENABLE		BIT(31)
> @@ -756,7 +757,7 @@ static int i3c_hci_init(struct i3c_hci *hci)
>   	/* Try activating DMA operations first */
>   	if (hci->RHS_regs) {
>   		reg_clear(HC_CONTROL, HC_CONTROL_PIO_MODE);
> -		if (reg_read(HC_CONTROL) & HC_CONTROL_PIO_MODE) {
> +		if (regval > HCI_VERSION_V1 && (reg_read(HC_CONTROL) & HC_CONTROL_PIO_MODE)) {
>   			dev_err(&hci->master.dev, "PIO mode is stuck\n");
>   			ret = -EIO;
>   		} else {

Actually here after this patch regval doesn't contain the version but 
HC_CONTROL which is read some line above. HCI_VERSION read is added by 
the patch 3/6 so this patch alone may cause a regression.

I'd say better to use already set hci->version_major and 
hci->version_minor since then code is not vulnerable if some other 
regval = reg_read(OTHER_REG) is added later before this code block.