Re: [PATCH 1/2] dt-bindings: mmc: renesas,sdhi: Add mux-states property

[Josua Mayer <josua@solid-run.com>]

Am 30.11.25 um 09:22 schrieb Krzysztof Kozlowski:
> On 28/11/2025 17:15, Josua Mayer wrote:
>> Add mux controller support for when sdio lines are muxed between a host
>> and multiple cards.
>>
>> There are several devices supporting a choice of eMMC or SD on a single
>> board by both dip switch and gpio, e.g. Renesas RZ/G2L SMARC SoM and
>> SolidRun RZ/G2L SoM.
>>
>> In-tree dts for the Renesas boards currently rely on preprocessor macros
>> to hog gpios and define the card.
>>
>> By adding mux-states property to sdio controller description, boards can
>> correctly describe the mux that already exists in hardware - and drivers
>> can coordinate between mux selection and probing for cards.
>>
>> Signed-off-by: Josua Mayer <josua@solid-run.com>
>> ---
>>  Documentation/devicetree/bindings/mmc/renesas,sdhi.yaml | 14 ++++++++++++++
>>  1 file changed, 14 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/mmc/renesas,sdhi.yaml b/Documentation/devicetree/bindings/mmc/renesas,sdhi.yaml
>> index c754ea71f51f7..55635c60ad73a 100644
>> --- a/Documentation/devicetree/bindings/mmc/renesas,sdhi.yaml
>> +++ b/Documentation/devicetree/bindings/mmc/renesas,sdhi.yaml
>> @@ -106,6 +106,11 @@ properties:
>>    iommus:
>>      maxItems: 1
>>  
>> +  mux-states:
>> +    description:
>> +      mux controller node to route the SDIO signals from SoC to cards.
>> +    maxItems: 1
>> +
>>    power-domains:
>>      maxItems: 1
>>  
>> @@ -262,9 +267,17 @@ unevaluatedProperties: false
>>  examples:
>>    - |
>>      #include <dt-bindings/clock/r8a7790-cpg-mssr.h>
>> +    #include <dt-bindings/gpio/gpio.h>
>>      #include <dt-bindings/interrupt-controller/arm-gic.h>
>> +    #include <dt-bindings/pinctrl/rzg2l-pinctrl.h>
>>      #include <dt-bindings/power/r8a7790-sysc.h>
>>  
>> +    mux: mux-controller {
>> +            compatible = "gpio-mux";
>> +            #mux-state-cells = <1>;
>> +            mux-gpios = <&pinctrl RZG2L_GPIO(22, 1) GPIO_ACTIVE_LOW>;
>
> Wrong indentation and not really relevant here, so just drop.
Ack.
>
> Best regards,
> Krzysztof