From: zhenwei pi <zhenwei.pi@linux.dev>
To: Zhu Yanjun <yanjun.zhu@linux.dev>,
linux-kernel@vger.kernel.org, linux-rdma@vger.kernel.org
Cc: zyjzyj2000@gmail.com, jgg@ziepe.ca, leon@kernel.org
Subject: Re: [PATCH v4 3/4] RDMA/rxe: add SENT/RCVD bytes
Date: Tue, 7 Apr 2026 08:58:57 +0800 [thread overview]
Message-ID: <cd0427bc-badd-4e54-ae91-e8ad6557fb95@linux.dev> (raw)
In-Reply-To: <92943fb0-b0ec-443e-a04f-204faba0c9cf@linux.dev>
On 4/6/26 22:55, Zhu Yanjun wrote:
> 在 2026/4/6 6:28, zhenwei pi 写道:
>> There is a lack of sent/received counter in bytes.
>>
>> Signed-off-by: zhenwei pi <zhenwei.pi@linux.dev>
>> ---
>> drivers/infiniband/sw/rxe/rxe_hw_counters.c | 2 ++
>> drivers/infiniband/sw/rxe/rxe_hw_counters.h | 2 ++
>> drivers/infiniband/sw/rxe/rxe_net.c | 2 ++
>> drivers/infiniband/sw/rxe/rxe_recv.c | 6 ++++++
>> drivers/infiniband/sw/rxe/rxe_verbs.h | 6 ++++++
>> 5 files changed, 18 insertions(+)
>>
>> diff --git a/drivers/infiniband/sw/rxe/rxe_hw_counters.c b/drivers/
>> infiniband/sw/rxe/rxe_hw_counters.c
>> index 437917a7d8f2..17edaa9a9b9b 100644
>> --- a/drivers/infiniband/sw/rxe/rxe_hw_counters.c
>> +++ b/drivers/infiniband/sw/rxe/rxe_hw_counters.c
>> @@ -22,6 +22,8 @@ static const struct rdma_stat_desc
>> rxe_counter_descs[] = {
>> [RXE_CNT_LINK_DOWNED].name = "link_downed",
>> [RXE_CNT_RDMA_SEND].name = "rdma_sends",
>> [RXE_CNT_RDMA_RECV].name = "rdma_recvs",
>> + [RXE_CNT_SENT_BYTES].name = "sent_bytes",
>> + [RXE_CNT_RCVD_BYTES].name = "rcvd_bytes",
>> };
>> int rxe_ib_get_hw_stats(struct ib_device *ibdev,
>> diff --git a/drivers/infiniband/sw/rxe/rxe_hw_counters.h b/drivers/
>> infiniband/sw/rxe/rxe_hw_counters.h
>> index 051f9e1c3852..01b355103cbc 100644
>> --- a/drivers/infiniband/sw/rxe/rxe_hw_counters.h
>> +++ b/drivers/infiniband/sw/rxe/rxe_hw_counters.h
>> @@ -26,6 +26,8 @@ enum rxe_counters {
>> RXE_CNT_LINK_DOWNED,
>> RXE_CNT_RDMA_SEND,
>> RXE_CNT_RDMA_RECV,
>> + RXE_CNT_SENT_BYTES,
>> + RXE_CNT_RCVD_BYTES,
>> RXE_NUM_OF_COUNTERS
>> };
>> diff --git a/drivers/infiniband/sw/rxe/rxe_net.c b/drivers/infiniband/
>> sw/rxe/rxe_net.c
>> index 6621d01ac32d..86660031ffa2 100644
>> --- a/drivers/infiniband/sw/rxe/rxe_net.c
>> +++ b/drivers/infiniband/sw/rxe/rxe_net.c
>> @@ -503,6 +503,7 @@ int rxe_xmit_packet(struct rxe_qp *qp, struct
>> rxe_pkt_info *pkt,
>> int err;
>> int is_request = pkt->mask & RXE_REQ_MASK;
>> struct rxe_dev *rxe = to_rdev(qp->ibqp.device);
>> + unsigned int skblen = skb->len;
>> unsigned long flags;
>> spin_lock_irqsave(&qp->state_lock, flags);
>> @@ -526,6 +527,7 @@ int rxe_xmit_packet(struct rxe_qp *qp, struct
>> rxe_pkt_info *pkt,
>> }
>> rxe_counter_inc(rxe, RXE_CNT_SENT_PKTS);
>> + rxe_counter_add(rxe, RXE_CNT_SENT_BYTES, skblen);
>> goto done;
>> drop:
>> diff --git a/drivers/infiniband/sw/rxe/rxe_recv.c b/drivers/
>> infiniband/sw/rxe/rxe_recv.c
>> index 5861e4244049..0d9112e95eae 100644
>> --- a/drivers/infiniband/sw/rxe/rxe_recv.c
>> +++ b/drivers/infiniband/sw/rxe/rxe_recv.c
>> @@ -318,6 +318,7 @@ void rxe_rcv(struct sk_buff *skb)
>> int err;
>> struct rxe_pkt_info *pkt = SKB_TO_PKT(skb);
>> struct rxe_dev *rxe = pkt->rxe;
>> + unsigned int skblen = skb->len + sizeof(struct udphdr);
>> if (unlikely(skb->len < RXE_BTH_BYTES))
>> goto drop;
>> @@ -341,6 +342,11 @@ void rxe_rcv(struct sk_buff *skb)
>> if (unlikely(err))
>> goto drop;
>> + if (skb->protocol == htons(ETH_P_IP))
>> + skblen += sizeof(struct iphdr);
>> + else if (skb->protocol == htons(ETH_P_IPV6))
>> + skblen += sizeof(struct ipv6hdr);
>> + rxe_counter_add(rxe, RXE_CNT_RCVD_BYTES, skblen);
>
> From the above source code, I think that you want to calculate total
> length starting from the Network Layer (IP Header).
> Maybe the following is compact.
>
> "
> unsigned int skblen = skb->len - skb_network_offset(skb);
> rxe_counter_add(rxe, RXE_CNT_RCVD_BYTES, skblen);
> "
>
> Zhu Yanjun
>
Yes, TX side uses the total length of IP + UDP + IB as sent bytes, RX
side should record the same length. Because IP and UDP headers have
already been pulled at this stage, so add the addional length here.
skb_network_offset(skb) is fine, I'll use it instead in the next version
later.
Thanks.
>> rxe_counter_inc(rxe, RXE_CNT_RCVD_PKTS);
>> if (unlikely(bth_qpn(pkt) == IB_MULTICAST_QPN))
>> diff --git a/drivers/infiniband/sw/rxe/rxe_verbs.h b/drivers/
>> infiniband/sw/rxe/rxe_verbs.h
>> index e800545d1046..0f5ffd94643f 100644
>> --- a/drivers/infiniband/sw/rxe/rxe_verbs.h
>> +++ b/drivers/infiniband/sw/rxe/rxe_verbs.h
>> @@ -455,6 +455,12 @@ static inline void rxe_counter_inc(struct rxe_dev
>> *rxe, enum rxe_counters index)
>> atomic64_inc(&rxe->stats_counters[index]);
>> }
>> +static inline void rxe_counter_add(struct rxe_dev *rxe, enum
>> rxe_counters index,
>> + s64 val)
>> +{
>> + atomic64_add(val, &rxe->stats_counters[index]);
>> +}
>> +
>> static inline struct rxe_dev *to_rdev(struct ib_device *dev)
>> {
>> return dev ? container_of(dev, struct rxe_dev, ib_dev) : NULL;
>
next prev parent reply other threads:[~2026-04-07 0:59 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-04-06 13:28 [PATCH v4 0/4] Support PERF MGMT for RXE zhenwei pi
2026-04-06 13:28 ` [PATCH v4 1/4] RDMA/core: Fix memory free for GID table zhenwei pi
2026-04-06 13:28 ` [PATCH v4 2/4] RDMA/rxe: remove rxe_ib_device_get_netdev() and RXE_PORT zhenwei pi
2026-04-06 13:28 ` [PATCH v4 3/4] RDMA/rxe: add SENT/RCVD bytes zhenwei pi
2026-04-06 14:55 ` Zhu Yanjun
2026-04-07 0:58 ` zhenwei pi [this message]
2026-04-06 13:28 ` [PATCH v4 4/4] RDMA/rxe: support perf mgmt GET method zhenwei pi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=cd0427bc-badd-4e54-ae91-e8ad6557fb95@linux.dev \
--to=zhenwei.pi@linux.dev \
--cc=jgg@ziepe.ca \
--cc=leon@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rdma@vger.kernel.org \
--cc=yanjun.zhu@linux.dev \
--cc=zyjzyj2000@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox