[RFC PATCH 0/2] MFD and GPIO for STA2X11

[Alessandro Rubini <rubini@gnudd.com>]

These two patches introduce multi-function device and GPIO support for
the STA2X11 I/O Hub. It's an RFC for both as explained below.

- I think the MFD driver is ok. This MFD_STA2X11 config symbol is
  autoselected by CONFIG_STA2X11, which is pending in the
  "x86: initial support for sta2x11" patch, for which I need to send V2
  later today, with some minor fixes.  Similarly, <asm/sta2x11.h> is
  not upstream yet, so I'll need to resend later, I suppose.

- The GPIO patch has a quirk: I chose to register a single irq chip
  for 128 interrupts but the generic irq_chip only support 32 interrupts.
  I'm sure the hack I did (request the irq descs myself) is not good, but
  what is the best approach here?  Using 4 generic irq chips or defining
  my own, non-generic one?

Thanks a lot
/alessandro

Alessandro Rubini (2):
  mfd: Add driver for STA2X11 MFD block
  gpio: add STA2X11 GPIO block

 drivers/gpio/Kconfig            |    9 +
 drivers/gpio/Makefile           |    1 +
 drivers/gpio/gpio-sta2x11.c     |  380 +++++++++++++++++++++++++++++++
 drivers/mfd/Kconfig             |    6 +
 drivers/mfd/Makefile            |    1 +
 drivers/mfd/sta2x11-mfd.c       |  470 +++++++++++++++++++++++++++++++++++++++
 include/linux/mfd/sta2x11-mfd.h |  186 +++++++++++++++
 7 files changed, 1053 insertions(+), 0 deletions(-)
 create mode 100644 drivers/gpio/gpio-sta2x11.c
 create mode 100644 drivers/mfd/sta2x11-mfd.c
 create mode 100644 include/linux/mfd/sta2x11-mfd.h

-- 
1.7.7.2