[PATCH v7 0/3] MIPS: Fixes and improvements for CI20 board (JZ4780)

H. Nikolaus Schaller
2020-03-06T21:06:45Z

* renamed DT node for IR receiver from ir-receiver to ir (suggested by Paul Cercueil <paul@crapouillou.net>)

PATCH V6 2020-03-06 18:29:34:
* reordered patches and send Fixes as separate ones (requested by Thomas Bogendoerfer <tsbogend@alpha.franken.de>)
* fixed Checkpatch issue with comments in PMU patch (suggested by Thomas Bogendoerfer <tsbogend@alpha.franken.de>)

PATCH V5 2020-02-29 20:45:52:
* add #include irq.h not in PMU patch but in RTC patch
* added Reviewed-by: Paul Cercueil <paul@crapouillou.net>

PATCH V4 2020-02-28 19:02:57:
* use KEY_F13 for SW1 button to avoid conflict with Enter of an USB keyboard (suggested by Paul Cercueil <paul@crapouillou.net>)
* tidy up all new #includes to be at beginning of file and alphabetically sorted (suggested by Paul Cercueil <paul@crapouillou.net>)
* add new #include to DTS only when needed (suggested by Paul Cercueil <paul@crapouillou.net>)

PATCH V3 2020-02-16 21:21:07:
* dropped "drm: ingenic-drm: add MODULE_DEVICE_TABLE" because it will be resubmitted
with a HDMI driver solution
* added Cc: stable@vger.kernel.org where appropriate (suggested by Paul Cercueil <paul@crapouillou.net>)
* squashed all other DTS and CONFIG changes into single patches (suggested by Paul Cercueil <paul@crapouillou.net>)

PATCH V2 2020-02-14 17:10:33:
* dropped "net: davicom: dm9000: allow to pass MAC address through mac_addr module parameter"
from this series because it goes through the netdev tree
(suggested by Andrew Lunn <andrew@lunn.ch>)
* added a "fixes:" for "MIPS: DTS: CI20: fix PMU definitions for ACT8600"
and "MIPS: DTS: CI20: fix interrupt for pcf8563 RTC"
(suggested by Andreas Kemnade <andreas@kemnade.info>)
* "i2c: jz4780: silence log flood on txabrt" dropped because it is
replaced by a new version in v5.6 by Wolfram Sang <wsa@the-dreams.de>

PATCH V1 2020-02-11 22:41:43:
This patch set provides several improvements for the CI20 board:

* suppress warnings from i2c if device is not responding
* make ingenic-drm found through DT
* allow davicom dm9000 ethernet controller to use MAC address provided by U-Boot
* fix #include in jz4780.dtsi
* configure for loadable kernel modules
* add DTS for IR sensor and SW1 button
* configure so that LEDs, IR sensor, SW1 button have drivers
* fix DTS for ACT8600 PMU and configure driver
* fix interrupt of nxp,pcf8563

There is another patch set in our queue to add HDMI support on top of this work.

Signed-off-by: Paul Boddie <paul@boddie.org.uk>
Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>

Alex Smith (1):
MIPS: DTS: CI20: add DT node for IR sensor

H. Nikolaus Schaller (2):
MIPS: DTS: CI20: multiple DTS improvements
MIPS: CI20: defconfig: multiple improvements

arch/mips/boot/dts/ingenic/ci20.dts | 19 +++++++++++++++++++
arch/mips/configs/ci20_defconfig | 21 +++++++++++++++++++++
2 files changed, 40 insertions(+)

--
2.23.0