Re: [REGRESSION][BISECTED] Screen goes blank with ASpeed AST2300 in 6.18-rc2

[Thomas Zimmermann <tzimmermann@suse.de>]

Hi

Am 22.10.25 um 11:16 schrieb Peter Schneider:
> Am 22.10.2025 um 11:11 schrieb Thomas Zimmermann:
>> Hi
>>
>> Am 22.10.25 um 10:08 schrieb Peter Schneider:
>>>
>>> Your patch applied cleanly against 6.18-rc2 and the kernel built 
>>> fine, but unfortunately it did not solve the issue: my console 
>>> screen stays blank after booting. This is regardless whether I do a 
>>> soft reboot, press the reset button or power cycle and do a cold 
>>> boot. They are all the same.
>>
>> Just to be sure: you do see output at the early boot stages (BIOS, 
>> boot loader). It's at some later point during boot, the driver loads 
>> and the display blanks out?
>
> Yes, that's correct.
>
>> There's another patch attached. does this make a difference?
>
> Do I have to apply that against base 6.18-rc2 or against 6.18-rc2 + 
> your previous patch?

Base 6.18-rc2. All the patches are against this.

Best regards
Thomas

>
>
> Beste Grüße,
> Peter Schneider
>

-- 
--
Thomas Zimmermann
Graphics Driver Developer
SUSE Software Solutions Germany GmbH
Frankenstrasse 146, 90461 Nuernberg, Germany
GF: Ivo Totev, Andrew Myers, Andrew McDonald, Boudien Moerman
HRB 36809 (AG Nuernberg)