[PATCH 11/15] ata: pata_legacy: Repair a couple kernel-doc problems

Lee Jones
2021-03-18T08:52:50Z

drivers/ata/pata_legacy.c:606: warning: expecting prototype for opt82c465mv_qc_issue(). Prototype was for opti82c46x_qc_issue() instead
drivers/ata/pata_legacy.c:933: warning: Function parameter or member 'probe' not described in 'legacy_init_one'
drivers/ata/pata_legacy.c:933: warning: Excess function parameter 'pl' description in 'legacy_init_one'
drivers/ata/pata_legacy.c:1024: warning: Function parameter or member 'primary' not described in 'legacy_check_special_cases'
drivers/ata/pata_legacy.c:1024: warning: Function parameter or member 'secondary' not described in 'legacy_check_special_cases'
drivers/ata/pata_legacy.c:1024: warning: Excess function parameter 'master' description in 'legacy_check_special_cases'
drivers/ata/pata_legacy.c:1024: warning: Excess function parameter 'master' description in 'legacy_check_special_cases'

Cc: Jens Axboe <axboe@kernel.dk>
Cc: Colten Edwards <pje120@cs.usask.ca>
Cc: Samuel Thibault <samuel.thibault@ens-lyon.org>
Cc: linux-ide@vger.kernel.org
Signed-off-by: Lee Jones <lee.jones@linaro.org>
---
drivers/ata/pata_legacy.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/ata/pata_legacy.c b/drivers/ata/pata_legacy.c
index 4fd12b20df239..a7235bde6ae87 100644
--- a/drivers/ata/pata_legacy.c
+++ b/drivers/ata/pata_legacy.c
@@ -588,7 +588,7 @@ static void opti82c46x_set_piomode(struct ata_port *ap, struct ata_device *adev)
}

/**
- * opt82c465mv_qc_issue - command issue
+ * opti82c46x_qc_issue - command issue
* @qc: command pending
*
* Called when the libata layer is about to issue a command. We wrap
@@ -923,7 +923,7 @@ static __init int probe_chip_type(struct legacy_probe *probe)

/**
* legacy_init_one - attach a legacy interface
- * @pl: probe record
+ * @probe: probe record
*
* Register an ISA bus IDE interface. Such interfaces are PIO and we
* assume do not support IRQ sharing.
@@ -1009,8 +1009,8 @@ static __init int legacy_init_one(struct legacy_probe *probe)
/**
* legacy_check_special_cases - ATA special cases
* @p: PCI device to check
- * @master: set this if we find an ATA master
- * @master: set this if we find an ATA secondary
+ * @primary: set this if we find an ATA master
+ * @secondary: set this if we find an ATA secondary
*
* A small number of vendors implemented early PCI ATA interfaces
* on bridge logic without the ATA interface being PCI visible.
--
2.27.0