Re: [PATCH v2] ARM: dts: aspeed: clemente: add MCTP over I2C support

[Andrew Jeffery <andrew@codeconstruct.com.au>]

Hi Leo,

On Mon, 2025-09-22 at 15:02 +0800, Leo Wang wrote:
> From: Leo Wang <leo.jt.wang@gmail.com>
> 
> Enable MCTP communication on the Meta Clemente BMC board:
> 
> - Add an MCTP I2C controller node at address 0x10 on I2C0
> - Mark selected I2C mux channels as MCTP controllers
> - Remove unused "i2c-mux-idle-disconnect" properties
> 
> This allows MCTP devices to be discovered and used for
> management communication on the Clemente platform.
> 
> Signed-off-by: Leo Wang <leo.jt.wang@gmail.com>
> ---
> Please consider the patch "[PATCH v1 1/1] ARM: dts: aspeed: clemente: add MCTP over I2C support"
> withdrawn.
> 
> After further review we determined that enabling MCTP in the Clemente device-tree is not
> required; the affected devices are managed through other mechanisms and adding MCTP nodes
> would be unnecessary. To avoid confusion and noise, please ignore the previous patch.
> 
> Original patch message-id: <20250918-leo-dts-transceiver-v1-1-3e2580325edc@gmail.com>
> ---
> Changes in v2:
> - Withdraw patch; no functional changes
> - Link to v1: https://lore.kernel.org/r/20250918-leo-dts-transceiver-v1-1-3e2580325edc@gmail.com
> ---

Please do not post a new revision of a series to announce withdrawal of
the series.

Rather, reply to the original series saying as much.

Thanks.

Andrew