From: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
To: Stefan Binding <sbinding@opensource.cirrus.com>,
Mark Brown <broonie@kernel.org>
Cc: alsa-devel@alsa-project.org, linux-kernel@vger.kernel.org,
patches@opensource.cirrus.com,
Richard Fitzgerald <rf@opensource.cirrus.com>
Subject: Re: [PATCH v2 2/8] ASoC: cs42l42: Add SOFT_RESET_REBOOT register
Date: Wed, 18 Jan 2023 10:41:18 -0600 [thread overview]
Message-ID: <eb9fe53e-013b-e477-1d14-8d0c1c7514fc@linux.intel.com> (raw)
In-Reply-To: <20230118160452.2385494-3-sbinding@opensource.cirrus.com>
On 1/18/23 10:04, Stefan Binding wrote:
> From: Richard Fitzgerald <rf@opensource.cirrus.com>
>
> The SOFT_RESET_REBOOT register is needed to recover CS42L42 state after
> a Soundwire bus reset.
Humm, you probably want to clarify the terminology, the 'soft reset' is
defined in the SoundWire spec as the case where the peripheral device
loses sync. Bus reset is a Severe Reset, but there's also a Hard Reset.
does this 'SOFT_RESET_REBOOT' need to be accessed when there's a soft
reset, or only after a Severe/Hard Reset?
>
> Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
> Signed-off-by: Stefan Binding <sbinding@opensource.cirrus.com>
> ---
> include/sound/cs42l42.h | 5 +++++
> sound/soc/codecs/cs42l42.c | 2 ++
> 2 files changed, 7 insertions(+)
>
> diff --git a/include/sound/cs42l42.h b/include/sound/cs42l42.h
> index 1d1c24fdd0cae..3994e933db195 100644
> --- a/include/sound/cs42l42.h
> +++ b/include/sound/cs42l42.h
> @@ -34,6 +34,7 @@
> #define CS42L42_PAGE_24 0x2400
> #define CS42L42_PAGE_25 0x2500
> #define CS42L42_PAGE_26 0x2600
> +#define CS42L42_PAGE_27 0x2700
> #define CS42L42_PAGE_28 0x2800
> #define CS42L42_PAGE_29 0x2900
> #define CS42L42_PAGE_2A 0x2A00
> @@ -720,6 +721,10 @@
>
> #define CS42L42_SRC_SDOUT_FS (CS42L42_PAGE_26 + 0x09)
>
> +/* Page 0x27 DMA */
> +#define CS42L42_SOFT_RESET_REBOOT (CS42L42_PAGE_27 + 0x01)
> +#define CS42L42_SFT_RST_REBOOT_MASK BIT(1)
> +
> /* Page 0x28 S/PDIF Registers */
> #define CS42L42_SPDIF_CTL1 (CS42L42_PAGE_28 + 0x01)
> #define CS42L42_SPDIF_CTL2 (CS42L42_PAGE_28 + 0x02)
> diff --git a/sound/soc/codecs/cs42l42.c b/sound/soc/codecs/cs42l42.c
> index 2fefbcf7bd130..82aa11d6937be 100644
> --- a/sound/soc/codecs/cs42l42.c
> +++ b/sound/soc/codecs/cs42l42.c
> @@ -293,6 +293,7 @@ bool cs42l42_readable_register(struct device *dev, unsigned int reg)
> case CS42L42_SPDIF_SW_CTL1:
> case CS42L42_SRC_SDIN_FS:
> case CS42L42_SRC_SDOUT_FS:
> + case CS42L42_SOFT_RESET_REBOOT:
> case CS42L42_SPDIF_CTL1:
> case CS42L42_SPDIF_CTL2:
> case CS42L42_SPDIF_CTL3:
> @@ -358,6 +359,7 @@ bool cs42l42_volatile_register(struct device *dev, unsigned int reg)
> case CS42L42_LOAD_DET_DONE:
> case CS42L42_DET_STATUS1:
> case CS42L42_DET_STATUS2:
> + case CS42L42_SOFT_RESET_REBOOT:
> return true;
> default:
> return false;
next prev parent reply other threads:[~2023-01-18 18:38 UTC|newest]
Thread overview: 25+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-01-18 16:04 [PATCH v2 0/8] ASoC: cs42l42: Add Soundwire support Stefan Binding
2023-01-18 16:04 ` [PATCH v2 1/8] soundwire: stream: Add specific prep/deprep commands to port_prep callback Stefan Binding
2023-01-18 16:37 ` Pierre-Louis Bossart
2023-01-18 16:04 ` [PATCH v2 2/8] ASoC: cs42l42: Add SOFT_RESET_REBOOT register Stefan Binding
2023-01-18 16:41 ` Pierre-Louis Bossart [this message]
2023-01-19 13:33 ` Richard Fitzgerald
2023-01-18 16:04 ` [PATCH v2 3/8] ASoC: cs42l42: Ensure MCLKint is a multiple of the sample rate Stefan Binding
2023-01-18 16:46 ` Pierre-Louis Bossart
2023-01-18 16:04 ` [PATCH v2 4/8] ASoC: cs42l42: Separate ASP config from PLL config Stefan Binding
2023-01-18 16:04 ` [PATCH v2 5/8] ASoC: cs42l42: Export some functions for Soundwire Stefan Binding
2023-01-18 16:04 ` [PATCH v2 6/8] ASoC: cs42l42: Add Soundwire support Stefan Binding
2023-01-18 17:41 ` Pierre-Louis Bossart
2023-01-19 13:58 ` Richard Fitzgerald
2023-01-19 14:48 ` Pierre-Louis Bossart
2023-01-19 15:35 ` Richard Fitzgerald
2023-01-19 16:27 ` Pierre-Louis Bossart
2023-01-20 12:31 ` Richard Fitzgerald
2023-01-20 19:55 ` Pierre-Louis Bossart
2023-01-23 15:51 ` Richard Fitzgerald
2023-01-23 16:05 ` Pierre-Louis Bossart
2023-01-23 16:14 ` Richard Fitzgerald
2023-01-23 16:25 ` Pierre-Louis Bossart
2023-01-18 16:04 ` [PATCH v2 7/8] ASoC: cs42l42: Don't set idle_bias_on Stefan Binding
2023-01-18 16:04 ` [PATCH v2 8/8] ASoC: cs42l42: Wait for debounce interval after resume Stefan Binding
2023-01-18 17:43 ` [PATCH v2 0/8] ASoC: cs42l42: Add Soundwire support Pierre-Louis Bossart
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=eb9fe53e-013b-e477-1d14-8d0c1c7514fc@linux.intel.com \
--to=pierre-louis.bossart@linux.intel.com \
--cc=alsa-devel@alsa-project.org \
--cc=broonie@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=patches@opensource.cirrus.com \
--cc=rf@opensource.cirrus.com \
--cc=sbinding@opensource.cirrus.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox