RE: [PATCH v6 4/5] dt-bindings: phy: realtek: Add the doc about the Realtek SoC USB 2.0 PHY

["Stanley Chang[昌育德]" <stanley_chang@realtek.com>]

Hi Rob,

> On Thu, Jun 29, 2023 at 01:45:12PM +0800, Stanley Chang wrote:
> > Add the documentation explain the property about Realtek USB PHY driver.
> 
> In the subject, drop "the doc about the". It's redundant. And perhaps add 'DHC
> RTD SoC' if this isn't for *all* Realtek SoCs.
> 
> > Realtek DHC (digital home center) RTD SoCs support DWC3 XHCI USB
> > controller. Added the driver to drive the USB 2.0 PHY transceivers.
> 
> driver? This is a binding for the h/w.

I mean, the driver is drivers/phy/realtek/phy-rtk-usb2.c
I will revise as
    dt-bindings: phy: realtek: Add the Realtek DHC RTD SoC USB 2.0 PHY

    Add the documentation explain the property about Realtek USB PHY driver.

    Realtek DHC (digital home center) RTD SoCs support DWC3 XHCI USB
    controller and uses phy-rtk-usb2 as driver for USB 2.0 PHY transceiver..

> > +$id: http://devicetree.org/schemas/phy/realtek,usb2phy.yaml#
> > +$schema: http://devicetree.org/meta-schemas/core.yaml#
> > +
> > +title: Realtek DHC SoCs USB 2.0 PHY
> > +
> > +maintainers:
> > +  - Stanley Chang <stanley_chang@realtek.com>
> > +
> > +description:
> 
> You need '|' if formatting (line breaks) are important.

I think I need it. I will add it.

> > +  realtek,inverse-hstx-sync-clock:
> > +    description:
> > +      For one of the phys of RTD1619b SoC, the synchronous clock of the
> > +      high-speed tx must be inverted.
> 
> "invert" assumes I know what non-inverted means. I do not. Better to state in
> terms of active high, low, falling edge, rising edge, etc.

Meaning, the clock must be reversed.
> 
> > +    type: boolean
> > +
> > +  realtek,driving-level:
> > +    description:
> > +      Control the magnitude of High speed Dp/Dm output swing.
> > +      For a different board or port, the original magnitude maybe not
> meet
> > +      the specification. In this situation we can adjust the value to meet
> > +      the specification.
> 
> What are the units?

There is no unit. It is only a gain for adjusting the magnitude. 

> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    default: 8
> > +    minimum: 0
> > +    maximum: 31
> > +
> > +  realtek,driving-compensate:
> 
> compensate what?

It is to compensate the driving level. In other word, to adjust the driving level.

Thanks,
Stanley