Re: TV card detected wrongly by the kernel. Any chance to get this fixed?

Manuel Reimer
2007-08-23T15:18:13Z

Mauro Carvalho Chehab wrote:
> If your board have an unique PCI ID, we may add it to the driver,
> avoiding this need. For this, we will need the results of the following
> command:
>
> lspci -vv -nn

I'm using card=65 to use my card. I never tried the tuner (don't need
it) but the composite-in works for displaying the input of my sattelite
receiver and I'm able to read videotext, too. Without "card=65", I only
got black/white output...

Here are the values of the lspci -vv -nn command. I reduced the output
to the two entries, belonging to the card.

00:10.0 Multimedia video controller [0400]: Brooktree Corporation Bt878
Video Capture [109e:036e] (rev 11)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (4000ns min, 10000ns max)
Interrupt: pin A routed to IRQ 10
Region 0: Memory at e7004000 (32-bit, prefetchable) [size=4K]
Capabilities: [44] Vital Product Data
Capabilities: [4c] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

00:10.1 Multimedia controller [0480]: Brooktree Corporation Bt878 Audio
Capture [109e:0878] (rev 11)
Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 10
Region 0: Memory at e7005000 (32-bit, prefetchable) [size=4K]
Capabilities: [44] Vital Product Data
Capabilities: [4c] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Thanks in advance for your answer.

CU

Manuel