Re: Linux 2.4.25-pre7 - no DRQ after issuing WRITE

["Gabor Z. Papp" <gzp@papp.hu>]

* Marcelo Tosatti <marcelo.tosatti@cyclades.com>:

| > Here we go: http://gzp.odpn.net/tmp/linux-2.4.25-pre7/
| >
| > The "no DRQ after issuing WRITE" problem with 2 120GB Seagate

...

| I'm not IDE expert, but these errors look like hardware fault for me
| (Bartlomiej CCed).
| 
| What about 2.6 and older 2.4 kernels on the same hardware ?

Same kernel works fine in a non-sw-raid environment, when I can't
stress enough the harddisks to fail. When I boot NetBSD 1.6.1, I'm
able to read-write the disks nonstop without any error. Thats why I
think its not hw problem, but I would like to use Linux 2.4, so I'm
waiting for Bartlomiej.

| -------------
| Mounted devfs on /dev
| Freeing unused kernel memory: 116k freed
| hde: dma_timer_expiry: dma status == 0x21
| hdg: dma_timer_expiry: dma status == 0x21
| hde: error waiting for DMA
| hde: dma timeout retry: status=0x7f { DriveReady DeviceFault SeekComplete
| DataRequest CorrectedError Index Error }
| hde: dma timeout retry: error=0x7f { DriveStatusError UncorrectableError
| SectorIdNotFound TrackZeroNotFound AddrMarkNotFound },
| LBAsect=9343692930943, high=556927, low=8355711, sector=4352
| hde: DMA disabled
| hdg: error waiting for DMA
| hdg: dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest
| }
| hdg: status error: status=0x50 { DriveReady SeekComplete }
| hdg: no DRQ after issuing MULTWRITE
| hdg: status timeout: status=0xd0 { Busy }