messages from 2026-08-02 21:04:48 to 2026-08-04 19:09:00 UTC [more...]
[PATCH RFC v3 0/7] mfd: ls2kbmc: multiple fixes for this driver
2026-08-04 19:08 UTC (17+ messages)
` [PATCH RFC v3 7/7] mfd: ls2kbmc: Capture the reset event of BMC through GPIO
[PATCH 00/21] net: phy: add X-Powers AC200/AC300 EPHY support
2026-08-04 18:29 UTC (65+ messages)
` [PATCH 01/21] dt-bindings: net: allwinner: add H616 EMAC1
` [PATCH 02/21] net: stmmac: sun8i: add support for Allwinner "
` [PATCH 03/21] arm64: dts: allwinner: h616: add EMAC1 controller
` [PATCH 04/21] net: mdio: factor out OF child registration helpers
` [PATCH 05/21] net: mdio: make device map changes hotplug-safe
` [PATCH 06/21] net: mdio: support dynamic OF device changes
` [PATCH 07/21] dt-bindings: net: x-powers: add AC200 EPHY control
` [PATCH 08/21] dt-bindings: mfd: x-powers: add AC200
` [PATCH 09/21] mfd: add X-Powers AC200 support
` [PATCH 10/21] net: phy: add X-Powers AC200 EPHY control driver
` [PATCH 11/21] dt-bindings: net: x-powers: add AC300 EPHY control
` [PATCH 12/21] net: phy: add X-Powers AC300 EPHY control driver
` [PATCH 13/21] dt-bindings: net: x-powers: add AC200/AC300 EPHY
` [PATCH 14/21] net: phy: support configuring PHY-autonomous Tx LPI
` [PATCH 15/21] net: phylink: allow PHY-autonomous EEE without MAC LPI
` [PATCH 16/21] net: phy: add X-Powers AC200/AC300 EPHY driver
` [PATCH 17/21] arm64: dts: allwinner: h616: add ACx00 EPHY resources
` [PATCH 18/21] arm64: dts: allwinner: orangepi-zero2w: enable Ethernet expansion
` [PATCH 19/21] arm64: dts: allwinner: h6: add AC200 EPHY resources
` [PATCH 20/21] arm64: dts: allwinner: h6: tanix: enable AC200 EPHY
` [PATCH 21/21] arm64: defconfig: enable X-Powers ACx00 Ethernet support
[PATCH v2 00/10] Support ROHM BD73800
2026-08-04 16:56 UTC (14+ messages)
` [PATCH v2 01/10] dt-bindings: mfd: common ROHM PMIC properties
` [PATCH v2 02/10] dt-bindings: rohm,bd*: Ref common ROHM bindings
` [PATCH v2 03/10] dt-bindings: regulator: ROHM BD73800 regulators
` [PATCH v2 04/10] dt-bindings: mfd: ROHM BD73800 PMIC
` [PATCH v2 05/10] mfd: Support for ROHM BD73800 PMIC core
` [PATCH v2 06/10] rtc: bd70528: Support RTC on ROHM BD73800
` [PATCH v2 07/10] regulator: bd71828: Support "
` [PATCH v2 08/10] clk: bd718x7: "
` [PATCH v2 09/10] gpio: bd73800: Support ROHM BD73800 PMIC GPIOs
` [PATCH v2 10/10] MAINTAINERS: Add ROHM BD73800 PMIC files
[PATCH 00/10] dt-bindings: mfd: Use generic power-controller schema
2026-08-04 16:14 UTC (21+ messages)
` [PATCH 01/10] dt-bindings: mfd: ene-kb[3]930: "
` [PATCH 02/10] dt-bindings: mfd: ti,tps65910: "
` [PATCH 03/10] dt-bindings: mfd: rockchip,rk8x: "
` [PATCH 04/10] dt-bindings: mfd: ricoh,rn5t618: "
` [PATCH 05/10] dt-bindings: mfd: netronix,ntxec: "
` [PATCH 06/10] dt-bindings: mfd: ti,twl: "
` [PATCH 07/10] dt-bindings: mfd: ti,tps6594: "
` [PATCH 08/10] dt-bindings: mfd: rohm,bd71828-pmic: "
` [PATCH 09/10] dt-bindings: mfd: fsl,mc13xxx: "
` [PATCH 10/10] dt-bindings: mfd: samsung,s2mpg10-pmic: "
[PATCH 0/4] Congatec Board Controller: Add storage devices support
2026-08-04 15:58 UTC (9+ messages)
` [PATCH 1/4] mfd: cgbc: Fix use of negative error code as valid session handle
` [PATCH 2/4] i2c: cgbc: Add virtual I2C bus support
` [PATCH 3/4] mfd: "
` [PATCH 4/4] i2c: cgbc: Add virtual storage devices on the virtual I2C bus
[PATCH] pinctrl: stm32: use a raw spinlock regmap to program the EXTI mux
2026-08-04 15:12 UTC (7+ messages)
` [PATCH v2] pinctrl: stm32: program the EXTI mux from .alloc instead of .activate
` [PATCH v3] "
[PATCH v24 00/12] Implement PSCI reboot mode driver for PSCI resets
2026-08-04 14:38 UTC (33+ messages)
` [PATCH v24 01/12] power: reset: reboot-mode: Support up to 3 magic values per mode
` [PATCH v24 02/12] power: reset: reboot-mode: Add support for predefined reboot modes
` [PATCH v24 03/12] firmware: psci: Introduce command-based resets
` [PATCH v24 04/12] mfd: psci-mfd: Add PSCI MFD driver for cpuidle-psci-domain cell
` [PATCH v24 05/12] dt-bindings: arm: Document reboot mode magic
` [PATCH v24 06/12] power: reset: Add psci-reboot-mode driver
` [PATCH v24 07/12] mfd: core: Add firmware-node support to MFD cells
` [PATCH v24 08/12] mfd: psci-mfd: Add psci-reboot-mode child cell
` [PATCH v24 09/12] arm64: dts: qcom: Add psci reboot-modes for kodiak boards
` [PATCH v24 10/12] arm64: dts: qcom: Add psci reboot-modes for lemans boards
` [PATCH v24 11/12] arm64: dts: qcom: Add psci reboot-modes for monaco boards
` [PATCH v24 12/12] arm64: dts: qcom: Add psci reboot-modes for talos boards
[PATCH RFC v5 0/7] mfd: ls2kbmc: multiple fixes for this driver
2026-08-04 13:56 UTC (20+ messages)
` [PATCH RFC v5 1/7] mfd: ls2kbmc: Make a copy when parsing mode string
` [PATCH RFC v5 2/7] mfd: ls2kbmc: Sanity check for the connected pci port
` [PATCH RFC v5 3/7] mfd: ls2kbmc: Redraw using exported functions
` [PATCH RFC v5 4/7] mfd: ls2kbmc: Cancel the work queue on removal
` [PATCH RFC v5 5/7] ipmi: ls2k: Relax the dependency to its mfd driver
` [PATCH RFC v5 6/7] mfd: ls2kbmc: Able to be compiled as a module
` [PATCH RFC v5 7/7] mfd: ls2kbmc: Capture the reset event of BMC through GPIO
[PATCH v4 0/5] thermal: loongson2: Add support for Loongson-2K0300 SoC
2026-08-04 13:01 UTC (11+ messages)
` [PATCH v4 1/5] thermal/drivers/loongson2: Correct thermal sensor registration loop
` [PATCH v4 2/5] thermal/drivers/loongson2: Move thermal_ops to chip_data for SoC scalability
` [PATCH v4 3/5] dt-bindings: mfd: syscon: Allow syscon compatible for Loongson-2K0300 chip id
` [PATCH v4 4/5] dt-bindings: thermal: loongson,ls2k-thermal: Add compatible for Loongson-2K0300
` [PATCH v4 5/5] thermal/drivers/loongson2: Add support "
[PATCH v3 0/5] thermal: loongson2: Add support for Loongson-2K0300 SoC
2026-08-04 7:49 UTC (4+ messages)
` [PATCH v3 3/5] dt-bindings: mfd: syscon: Allow syscon compatible for Loongson-2K0300 chip id
[PATCH v9 00/12] ZTE zx297520v3 clock bindings and driver
2026-08-04 6:37 UTC (15+ messages)
` [PATCH v9 01/12] dt-bindings: clk: zte: Add zx297520v3 top clock and reset controller
` [PATCH v9 05/12] clk: zte: Add Clock registration infrastructure
` [PATCH v9 06/12] clk: zte: Add regmap-based clocks
` [PATCH v9 07/12] clk: zte: Add zx PLL support infrastructure
` [PATCH v9 09/12] clk: zte: Introduce a driver for zx297520v3 matrix clocks
` [PATCH v9 11/12] reset: zte: Add a zx297520v3 reset driver
[PATCH] dt-bindings: Correct white-space style
2026-08-03 22:29 UTC (4+ messages)
[PATCH v2] fpga: m10bmc-sec: add image_load sysfs for N3000 and D5005
2026-08-03 13:22 UTC (3+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).