From: Andrew Morton <akpm@linux-foundation.org>
To: mm-commits@vger.kernel.org,vbabka@kernel.org,surenb@google.com,rppt@kernel.org,peterz@infradead.org,mj0123.lee@samsung.com,mhocko@suse.com,ljs@kernel.org,liam@infradead.org,jack@suse.cz,david@kernel.org,nickolai@csail.mit.edu,akpm@linux-foundation.org
Subject: [merged mm-stable] mm-bdi-reset-min_ratio-after-the-sysfs-attributes-are-gone.patch removed from -mm tree
Date: Sat, 24 Oct 2026 02:02:11 -0700 [thread overview]
Message-ID: <20261024090211.7B00F1F01828@smtp.kernel.org> (raw)
The quilt patch titled
Subject: mm: bdi: reset min_ratio after the sysfs attributes are gone
has been removed from the -mm tree. Its filename was
mm-bdi-reset-min_ratio-after-the-sysfs-attributes-are-gone.patch
This patch was dropped because it was merged into the mm-stable branch
of git://git.kernel.org/pub/scm/linux/kernel/git/akpm/mm
------------------------------------------------------
From: Nickolai Zeldovich <nickolai@csail.mit.edu>
Subject: mm: bdi: reset min_ratio after the sysfs attributes are gone
Date: Fri, 16 Oct 2026 23:06:20 -0400
A write to /sys/class/bdi/<dev>/min_ratio (or min_ratio_fine or min_bytes)
that races with the removal of the device leaves the global sum of minimum
dirty shares charged for a bdi that no longer exists. Until the next
reboot, that share of the dirty threshold is withheld from every other bdi
(__wb_calc_thresh() scales by 100 % minus the sum), and a later min_ratio
store on any bdi that would push the sum to 100 % fails with EINVAL
although every bdi reads 0. Root privilege is needed for the store; the
removal is any del_gendisk() (a disk or loop device going away) or the
unmount of a filesystem with its own bdi. On an x86_64 defconfig kernel
(v7.3-rc7), 2000 rounds of LOOP_CTL_ADD/LOOP_CTL_REMOVE on one loop device
with a second thread writing 50 to its min_ratio leak the share on the
first round the store lands in the window; afterwards `echo 99 >
min_ratio` on another loop device fails with EINVAL. With the fix the
same run keeps the sum at 0 and the store succeeds. Affected since v5.16,
when the reset in bdi_unregister() was added.
bdi_unregister() gives the bdi's share back with bdi_set_min_ratio(bdi, 0)
and only then calls device_unregister(), which removes the sysfs
attributes. A min_ratio_store() that gets its kernfs active reference
before the removal runs to completion after the reset:
__bdi_set_min_ratio() takes bdi_lock, sees bdi->min_ratio == 0, adds the
new value to bdi_min_ratio and stores it in the bdi, which bdi_put() then
frees. Nothing gives that share back.
Move the reset after device_unregister(): once the attributes are gone no
store can run, and bdi_set_min_ratio() needs nothing from the device.
Found while formally verifying bdi_unregister() against the kernel binary.
Link: https://lore.kernel.org/20261017030620.793108-1-nickolai@csail.mit.edu
Fixes: 3c376dfafbf7 ("mm: bdi: initialize bdi_min_ratio when bdi is unregistered")
Signed-off-by: Nickolai Zeldovich <nickolai@csail.mit.edu>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Reviewed-by: Jan Kara <jack@suse.cz>
Assisted-by: LLM
Cc: David Hildenbrand <david@kernel.org>
Cc: Lorenzo Stoakes <ljs@kernel.org>
Cc: Liam R. Howlett <liam@infradead.org>
Cc: Vlastimil Babka <vbabka@kernel.org>
Cc: Mike Rapoport <rppt@kernel.org>
Cc: Suren Baghdasaryan <surenb@google.com>
Cc: Michal Hocko <mhocko@suse.com>
Cc: Peter Zijlstra <peterz@infradead.org>
Cc: Manjong Lee <mj0123.lee@samsung.com>
---
mm/backing-dev.c | 15 ++++++++-------
1 file changed, 8 insertions(+), 7 deletions(-)
--- a/mm/backing-dev.c~mm-bdi-reset-min_ratio-after-the-sysfs-attributes-are-gone
+++ a/mm/backing-dev.c
@@ -1162,19 +1162,20 @@ void bdi_unregister(struct backing_dev_i
wb_shutdown(&bdi->wb);
cgwb_bdi_unregister(bdi);
- /*
- * If this BDI's min ratio has been set, use bdi_set_min_ratio() to
- * update the global bdi_min_ratio.
- */
- if (bdi->min_ratio)
- bdi_set_min_ratio(bdi, 0);
-
if (bdi->dev) {
bdi_debug_unregister(bdi);
device_unregister(bdi->dev);
bdi->dev = NULL;
}
+ /*
+ * If this BDI's min ratio has been set, use bdi_set_min_ratio() to
+ * update the global bdi_min_ratio. After device_unregister(): the
+ * sysfs min_ratio stores can no longer run and set it again.
+ */
+ if (bdi->min_ratio)
+ bdi_set_min_ratio(bdi, 0);
+
if (bdi->owner) {
put_device(bdi->owner);
bdi->owner = NULL;
_
Patches currently in -mm which might be from nickolai@csail.mit.edu are
xarray-clear-the-new-heads-parent-before-freeing-the-old-head.patch
mm-vmalloc-read-vm_map_ram-block-regions-from-the-requested-offset.patch
reply other threads:[~2026-10-24 9:02 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261024090211.7B00F1F01828@smtp.kernel.org \
--to=akpm@linux-foundation.org \
--cc=david@kernel.org \
--cc=jack@suse.cz \
--cc=liam@infradead.org \
--cc=ljs@kernel.org \
--cc=mhocko@suse.com \
--cc=mj0123.lee@samsung.com \
--cc=mm-commits@vger.kernel.org \
--cc=nickolai@csail.mit.edu \
--cc=peterz@infradead.org \
--cc=rppt@kernel.org \
--cc=surenb@google.com \
--cc=vbabka@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox