From mboxrd@z Thu Jan 1 00:00:00 1970 From: Steven Whitehouse Subject: Re: My 802.3ad is my bond Date: Wed, 23 Jan 2008 17:19:38 +0000 Message-ID: <1201108778.22038.261.camel@quoit> References: <1201103100.22038.254.camel@quoit> <26889.1201108405@death> Mime-Version: 1.0 Content-Type: text/plain Content-Transfer-Encoding: 7bit Cc: netdev@vger.kernel.org To: Jay Vosburgh Return-path: Received: from mx1.redhat.com ([66.187.233.31]:39107 "EHLO mx1.redhat.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1756725AbYAWR1i (ORCPT ); Wed, 23 Jan 2008 12:27:38 -0500 In-Reply-To: <26889.1201108405@death> Sender: netdev-owner@vger.kernel.org List-ID: Hi, On Wed, 2008-01-23 at 09:13 -0800, Jay Vosburgh wrote: > Steven Whitehouse wrote: > [...] > >This commit: ece95f7fefe3afae19e641e1b3f5e64b00d5b948 seems to have > >caused a problem with parsing bond arguments as now only the numeric > >arguments seem to work (in modprobe.conf) and specifying 802.3ad fails. > >When I revert that patch in my local tree all seems ok. > > Thanks for the report; I know what the problem here is. I'll > get a fix out. > > >Also I notice that one of my two NICs now reports this: > > > >bonding: bond0: link status definitely down for interface eth0, > >disabling it > >bonding: bond0: Interface eth0 is already enslaved! > >bond0.5: no IPv6 routers present > > > >which I think is also new with this set of bonding updates, before it > >used to use both interfaces ok. I've not worked out which of the other > >patches causes this so far, but I can if its helpful, > > That would be helpful, as would some more details: e.g., the > various options passed to bonding, the complete dmesg log, contents of > /proc/net/bonding/bond0 [or whatever your interface is called], and > anything else you think would be helpful. > > -J > > --- > -Jay Vosburgh, IBM Linux Technology Center, fubar@us.ibm.com Ok. I'll try and work out which patch it is, but in the mean time: Ethernet Channel Bonding Driver: v3.2.3 (December 6, 2007) Bonding Mode: IEEE 802.3ad Dynamic link aggregation Transmit Hash Policy: layer2 (0) MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 802.3ad info LACP rate: slow Active Aggregator Info: Aggregator ID: 1 Number of ports: 1 Actor Key: 17 Partner Key: 4 Partner Mac Address: 00:12:a9:13:3f:67 Slave Interface: eth0 MII Status: down <-- this one should be up as well Link Failure Count: 2 Permanent HW addr: 00:11:43:d7:75:74 Aggregator ID: 2 Slave Interface: eth1 MII Status: up Link Failure Count: 1 Permanent HW addr: 00:11:43:d7:75:75 Aggregator ID: 1 Bonding options: options bond0 miimon=100 mode=802.3ad I'll send the dmesg by private email as its quite large, Steve.