From mboxrd@z Thu Jan 1 00:00:00 1970 From: Ben Hutchings Subject: [PATCH 01/20] sfc: SFT9001: Include non-breaking cable diagnostics in online self-tests Date: Thu, 29 Jan 2009 19:15:21 +0000 Message-ID: <1233256521.3656.12.camel@achroite> References: <1233256358.3656.9.camel@achroite> Mime-Version: 1.0 Content-Type: text/plain Content-Transfer-Encoding: 7bit Cc: netdev@vger.kernel.org, linux-net-drivers@solarflare.com To: David Miller Return-path: Received: from smarthost03.mail.zen.net.uk ([212.23.3.142]:53141 "EHLO smarthost03.mail.zen.net.uk" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751824AbZA2TPY (ORCPT ); Thu, 29 Jan 2009 14:15:24 -0500 In-Reply-To: <1233256358.3656.9.camel@achroite> Sender: netdev-owner@vger.kernel.org List-ID: Signed-off-by: Ben Hutchings --- drivers/net/sfc/tenxpress.c | 45 ++++++++++++++++++++++-------------------- 1 files changed, 24 insertions(+), 21 deletions(-) diff --git a/drivers/net/sfc/tenxpress.c b/drivers/net/sfc/tenxpress.c index 9ecb77d..9f5c8b8 100644 --- a/drivers/net/sfc/tenxpress.c +++ b/drivers/net/sfc/tenxpress.c @@ -708,12 +708,10 @@ static int sft9001_run_tests(struct efx_nic *efx, int *results, unsigned flags) { struct ethtool_cmd ecmd; int phy_id = efx->mii.phy_id; - int rc = 0, rc2, i, res_reg; + int rc = 0, rc2, i, ctrl_reg, res_reg; - if (!(flags & ETH_TEST_FL_OFFLINE)) - return 0; - - efx->phy_op->get_settings(efx, &ecmd); + if (flags & ETH_TEST_FL_OFFLINE) + efx->phy_op->get_settings(efx, &ecmd); /* Initialise cable diagnostic results to unknown failure */ for (i = 1; i < 9; ++i) @@ -721,18 +719,22 @@ static int sft9001_run_tests(struct efx_nic *efx, int *results, unsigned flags) /* Run cable diagnostics; wait up to 5 seconds for them to complete. * A cable fault is not a self-test failure, but a timeout is. */ + ctrl_reg = ((1 << CDIAG_CTRL_IMMED_LBN) | + (CDIAG_CTRL_LEN_METRES << CDIAG_CTRL_LEN_UNIT_LBN)); + if (flags & ETH_TEST_FL_OFFLINE) { + /* Break the link in order to run full diagnostics. We + * must reset the PHY to resume normal service. */ + ctrl_reg |= (1 << CDIAG_CTRL_BRK_LINK_LBN); + } mdio_clause45_write(efx, phy_id, MDIO_MMD_PMAPMD, - PMA_PMD_CDIAG_CTRL_REG, - (1 << CDIAG_CTRL_IMMED_LBN) | - (1 << CDIAG_CTRL_BRK_LINK_LBN) | - (CDIAG_CTRL_LEN_METRES << CDIAG_CTRL_LEN_UNIT_LBN)); + PMA_PMD_CDIAG_CTRL_REG, ctrl_reg); i = 0; while (mdio_clause45_read(efx, phy_id, MDIO_MMD_PMAPMD, PMA_PMD_CDIAG_CTRL_REG) & (1 << CDIAG_CTRL_IN_PROG_LBN)) { if (++i == 50) { rc = -ETIMEDOUT; - goto reset; + goto out; } msleep(100); } @@ -757,17 +759,18 @@ static int sft9001_run_tests(struct efx_nic *efx, int *results, unsigned flags) results[5 + i] = len_reg; } - /* We must reset to exit cable diagnostic mode. The BIST will - * also run when we do this. */ -reset: - rc2 = tenxpress_special_reset(efx); - results[0] = rc2 ? -1 : 1; - if (!rc) - rc = rc2; - - rc2 = efx->phy_op->set_settings(efx, &ecmd); - if (!rc) - rc = rc2; +out: + if (flags & ETH_TEST_FL_OFFLINE) { + /* Reset, running the BIST and then resuming normal service. */ + rc2 = tenxpress_special_reset(efx); + results[0] = rc2 ? -1 : 1; + if (!rc) + rc = rc2; + + rc2 = efx->phy_op->set_settings(efx, &ecmd); + if (!rc) + rc = rc2; + } return rc; } -- Ben Hutchings, Senior Software Engineer, Solarflare Communications Not speaking for my employer; that's the marketing department's job. They asked us to note that Solarflare product names are trademarked.