Re: [linux-pm] power draw depending on PHY speed

[Ben Hutchings <bhutchings@solarflare.com>]

On Fri, 2009-08-28 at 21:03 +0200, Rafael J. Wysocki wrote:
> On Friday 28 August 2009, Leisner, Martin wrote:
> > While doing some current probe measurements (i.e. to measure the effects
> > of NAP and frequency scaling with a freescale processor) I noticed some
> > very
> > significant differents if we ran on 100Mbit of 1000Mbit ethernet.
> > 
> > The hardware guys like at their data sheets and agreed.
> > 
> > Does anyone "drop ethernet speed" to save power?
> > (when a system is idle, is isn't necessary to run 1G ethernet).
> 
> I don't know, really.  This is a netdev question IMO (CC added).

Doing this through the existing autonegotiation mechanism is a bad idea,
because it requires bringing the link down, possibly for a few seconds.
There is a standard on the way (802.3az, aka Energy-Efficient Ethernet
or EEE) which will allow for speed renegotiation without dropping the
link.

> > When a system has WOL capability, what speed does it run at when the
> > system is sleeping?
> 
> That's a very good question.  I bet that depends on the NIC in question, at
> least I'm not sure if any spec regulates it.

I'm not aware of a spec, but generally a 1G or 10G multi-speed PHY will
not advertise speeds higher than 100 Mbit/s when sleeping.

Ben.

-- 
Ben Hutchings, Senior Software Engineer, Solarflare Communications
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.