[PATCH NEXT 2/5] qlcnic: disable tx timeout recovery

[amit.salecha@qlogic.com]

From: Amit Kumar Salecha <amit.salecha@qlogic.com>

Disable tx timeout recovery, if auto_fw_reset is disable

Signed-off-by: Amit Kumar Salecha <amit.salecha@qlogic.com>
---
 drivers/net/qlcnic/qlcnic_main.c |    6 ++++--
 1 files changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/net/qlcnic/qlcnic_main.c b/drivers/net/qlcnic/qlcnic_main.c
index 4d18313..d511fd1 100644
--- a/drivers/net/qlcnic/qlcnic_main.c
+++ b/drivers/net/qlcnic/qlcnic_main.c
@@ -2581,7 +2581,8 @@ qlcnic_check_health(struct qlcnic_adapter *adapter)
 		if (adapter->need_fw_reset)
 			goto detach;
 
-		if (adapter->reset_context) {
+		if (adapter->reset_context &&
+				auto_fw_reset == AUTO_FW_RESET_ENABLED) {
 			qlcnic_reset_hw_context(adapter);
 			adapter->netdev->trans_start = jiffies;
 		}
@@ -2594,7 +2595,8 @@ qlcnic_check_health(struct qlcnic_adapter *adapter)
 
 	qlcnic_dev_request_reset(adapter);
 
-	clear_bit(__QLCNIC_FW_ATTACHED, &adapter->state);
+	if ((auto_fw_reset == AUTO_FW_RESET_ENABLED))
+		clear_bit(__QLCNIC_FW_ATTACHED, &adapter->state);
 
 	dev_info(&netdev->dev, "firmware hang detected\n");
 
-- 
1.6.0.2