[PATCH] net: ehea: fix wrongly-reported supported modes

[Kleber Sacilotto de Souza <klebers@linux.vnet.ibm.com>]

Currently EHEA reports to ethtool as supporting 10000baseT_Full and
FIBRE independent of the hardware configuration. However, these
capabilities should be reported only if the physical port and
the medium support them, which is the case where the physical port
is connected at 10Gb.

Signed-off-by: Kleber Sacilotto de Souza <klebers@linux.vnet.ibm.com>
---
 drivers/net/ehea/ehea_ethtool.c |   21 ++++++++++++++-------
 1 files changed, 14 insertions(+), 7 deletions(-)

diff --git a/drivers/net/ehea/ehea_ethtool.c b/drivers/net/ehea/ehea_ethtool.c
index 3e2e734..04716c2 100644
--- a/drivers/net/ehea/ehea_ethtool.c
+++ b/drivers/net/ehea/ehea_ethtool.c
@@ -55,15 +55,22 @@ static int ehea_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 		cmd->duplex = -1;
 	}

-	cmd->supported = (SUPPORTED_10000baseT_Full | SUPPORTED_1000baseT_Full
-		       | SUPPORTED_100baseT_Full |  SUPPORTED_100baseT_Half
-		       | SUPPORTED_10baseT_Full | SUPPORTED_10baseT_Half
-		       | SUPPORTED_Autoneg | SUPPORTED_FIBRE);
+	cmd->supported = (SUPPORTED_1000baseT_Full | SUPPORTED_100baseT_Full
+		       | SUPPORTED_100baseT_Half | SUPPORTED_10baseT_Full
+		       | SUPPORTED_10baseT_Half | SUPPORTED_Autoneg);

-	cmd->advertising = (ADVERTISED_10000baseT_Full | ADVERTISED_Autoneg
-			 | ADVERTISED_FIBRE);
+	cmd->advertising = ADVERTISED_Autoneg;
+
+	if (cmd->speed == SPEED_10000) {
+		cmd->supported |= (SUPPORTED_10000baseT_Full | SUPPORTED_FIBRE);
+		cmd->advertising |= (ADVERTISED_10000baseT_Full | ADVERTISED_FIBRE);
+		cmd->port = PORT_FIBRE;
+	} else {
+		cmd->supported |= SUPPORTED_TP;
+		cmd->advertising |= (ADVERTISED_1000baseT_Full | ADVERTISED_TP);
+		cmd->port = PORT_TP;
+	}

-	cmd->port = PORT_FIBRE;
 	cmd->autoneg = port->autoneg == 1 ? AUTONEG_ENABLE : AUTONEG_DISABLE;

 	return 0;
-- 
1.7.1