[PATCH] ehea: fix wrongly reported speed and port

[Kleber Sacilotto de Souza <klebers@linux.vnet.ibm.com>]

Currently EHEA reports to ethtool as supporting 10M, 100M, 1G and
10G and connected to FIBRE independent of the hardware configuration.
However, when connected to FIBRE the only supported speed is 10G
full-duplex, and the other speeds and modes are only supported
when connected to twisted pair.

Signed-off-by: Kleber Sacilotto de Souza <klebers@linux.vnet.ibm.com>
---
 drivers/net/ehea/ehea_ethtool.c |   21 +++++++++++++--------
 1 files changed, 13 insertions(+), 8 deletions(-)

diff --git a/drivers/net/ehea/ehea_ethtool.c b/drivers/net/ehea/ehea_ethtool.c
index 3e2e734..f3bbdce 100644
--- a/drivers/net/ehea/ehea_ethtool.c
+++ b/drivers/net/ehea/ehea_ethtool.c
@@ -55,15 +55,20 @@ static int ehea_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 		cmd->duplex = -1;
 	}

-	cmd->supported = (SUPPORTED_10000baseT_Full | SUPPORTED_1000baseT_Full
-		       | SUPPORTED_100baseT_Full |  SUPPORTED_100baseT_Half
-		       | SUPPORTED_10baseT_Full | SUPPORTED_10baseT_Half
-		       | SUPPORTED_Autoneg | SUPPORTED_FIBRE);
-
-	cmd->advertising = (ADVERTISED_10000baseT_Full | ADVERTISED_Autoneg
-			 | ADVERTISED_FIBRE);
+	if (cmd->speed == SPEED_10000) {
+		cmd->supported = (SUPPORTED_10000baseT_Full | SUPPORTED_FIBRE);
+		cmd->advertising = (ADVERTISED_10000baseT_Full | ADVERTISED_FIBRE);
+		cmd->port = PORT_FIBRE;
+	} else {
+		cmd->supported = (SUPPORTED_1000baseT_Full | SUPPORTED_100baseT_Full
+			       | SUPPORTED_100baseT_Half | SUPPORTED_10baseT_Full
+			       | SUPPORTED_10baseT_Half | SUPPORTED_Autoneg
+			       | SUPPORTED_TP);
+		cmd->advertising = (ADVERTISED_1000baseT_Full | ADVERTISED_Autoneg
+				 | ADVERTISED_TP);
+		cmd->port = PORT_TP;
+	}

-	cmd->port = PORT_FIBRE;
 	cmd->autoneg = port->autoneg == 1 ? AUTONEG_ENABLE : AUTONEG_DISABLE;

 	return 0;
-- 
1.7.1