Re: [PATCH] bonding: reset queue mapping prior to transmission to physical device (v4)

[Eric Dumazet <eric.dumazet@gmail.com>]

Le vendredi 03 juin 2011 à 15:57 -0400, Neil Horman a écrit :
> On Fri, Jun 03, 2011 at 09:48:51PM +0200, Eric Dumazet wrote:
> > Le vendredi 03 juin 2011 à 15:24 -0400, Neil Horman a écrit :
> > > The bonding driver is multiqueue enabled, in which each queue represents a slave
> > > to enable optional steering of output frames to given slaves against the default
> > > output policy.  However, it needs to reset the skb->queue_mapping prior to
> > > queuing to the physical device or the physical slave (if it is multiqueue) could
> > > wind up transmitting on an unintended tx queue
> > > 
> > > Change Notes:
> > > v2) Based on first pass review, updated the patch to restore the origional queue
> > > mapping that was found in bond_select_queue, rather than simply resetting to
> > > zero.  This preserves the value of queue_mapping when it was set on receive in
> > > the forwarding case which is desireable.
> > > 
> > > v3) Fixed spelling an casting error in skb->cb
> > > 
> > > v4) fixed to store raw queue_mapping to avoid double decrement
> > > 
> > > Signed-off-by: Neil Horman <nhorman@tuxdriver.com>
> > > CC: Jay Vosburgh <fubar@us.ibm.com>
> > > CC: Andy Gospodarek <andy@greyhouse.net>
> > > CC: "David S. Miller" <davem@davemloft.net>
> > > ---
> > >  drivers/net/bonding/bond_main.c |    8 ++++++++
> > >  1 files changed, 8 insertions(+), 0 deletions(-)
> > > 
> > > diff --git a/drivers/net/bonding/bond_main.c b/drivers/net/bonding/bond_main.c
> > > index 17b4dd9..76adf27 100644
> > > --- a/drivers/net/bonding/bond_main.c
> > > +++ b/drivers/net/bonding/bond_main.c
> > > @@ -400,6 +400,9 @@ int bond_dev_queue_xmit(struct bonding *bond, struct sk_buff *skb,
> > >  {
> > >  	skb->dev = slave_dev;
> > >  	skb->priority = 1;
> > > +
> > > +	skb->queue_mapping = ((u16 *)skb->cb)[0];
> > 
> > Please dont do that. Use a helper.
> > 
> Why?  It seems to be reasonably common practice for drivers to access
> queue_mapping directly.
> 
> Examples can be found in:
> ixgbe_xmit_frame
> mlx4_en_xmit
> qlge_send
> igb_xmit_frame_adv
> gfar_start_xmit
> 
> among others.
> 
> Not saying its correct to do so necessecarily, but it seems a helper doesn't buy
> us much here, particularly a per-driver helper.  If a helper really should be
> used, why not just consistently use skb_get_queue_mapping?
> Neil

I was speaking of skb->cb access, of course, sorry if you missed my
point ;)

Please take a look at various files using helpers for this.

For example : net/ipv4/igmp.c

#define igmp_skb_size(skb) (*(unsigned int *)((skb)->cb))