[PATCH net-next 07/10] tg3: Remove unused link config code

[PATCH net-next 07/10] tg3: Remove unused link config code

[Matt Carlson]

When tg3 devices are shutdown, the driver uses the
TG3_PHYFLG_IS_LOW_POWER flag to enable a static phy configuration.
Any attempt to use the link configuration variables is dead code.  This
patch removes such code.

Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
---
 drivers/net/ethernet/broadcom/tg3.c |    6 +-----
 1 files changed, 1 insertions(+), 5 deletions(-)

diff --git a/drivers/net/ethernet/broadcom/tg3.c b/drivers/net/ethernet/broadcom/tg3.c
index 27cf74c..610997c 100644
--- a/drivers/net/ethernet/broadcom/tg3.c
+++ b/drivers/net/ethernet/broadcom/tg3.c
@@ -3607,12 +3607,8 @@ static int tg3_power_down_prepare(struct tg3 *tp)
 			tp->link_config.orig_autoneg = tp->link_config.autoneg;
 		}
 
-		if (!(tp->phy_flags & TG3_PHYFLG_ANY_SERDES)) {
-			tp->link_config.speed = SPEED_10;
-			tp->link_config.duplex = DUPLEX_HALF;
-			tp->link_config.autoneg = AUTONEG_ENABLE;
+		if (!(tp->phy_flags & TG3_PHYFLG_ANY_SERDES))
 			tg3_setup_phy(tp, 0);
-		}
 	}
 
 	if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5906) {
-- 
1.7.3.4