From: Ben Hutchings <bhutchings@solarflare.com>
To: David Miller <davem@davemloft.net>
Cc: <netdev@vger.kernel.org>, <linux-net-drivers@solarflare.com>
Subject: [PATCH net-next 03/19] sfc: Replace some literal constants with EFX_PAGE_SIZE/EFX_BUF_SIZE
Date: Thu, 16 Feb 2012 00:45:11 +0000 [thread overview]
Message-ID: <1329353111.2565.29.camel@bwh-desktop> (raw)
In-Reply-To: <1329352938.2565.26.camel@bwh-desktop>
The 'page size' for PCIe DMA, i.e. the alignment of boundaries at
which DMA must be broken, is 4KB. Name this value as EFX_PAGE_SIZE
and use it in efx_max_tx_len(). Redefine EFX_BUF_SIZE as
EFX_PAGE_SIZE since its value is also a result of that requirement,
and use it in efx_init_special_buffer().
Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
---
drivers/net/ethernet/sfc/nic.c | 5 +----
drivers/net/ethernet/sfc/nic.h | 5 +++++
drivers/net/ethernet/sfc/tx.c | 2 +-
3 files changed, 7 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/sfc/nic.c b/drivers/net/ethernet/sfc/nic.c
index a43d1ca..dd50c4f 100644
--- a/drivers/net/ethernet/sfc/nic.c
+++ b/drivers/net/ethernet/sfc/nic.c
@@ -54,9 +54,6 @@
#define EFX_FLUSH_INTERVAL 10
#define EFX_FLUSH_POLL_COUNT 100
-/* Size and alignment of special buffers (4KB) */
-#define EFX_BUF_SIZE 4096
-
/* Depth of RX flush request fifo */
#define EFX_RX_FLUSH_COUNT 4
@@ -196,7 +193,7 @@ efx_init_special_buffer(struct efx_nic *efx, struct efx_special_buffer *buffer)
/* Write buffer descriptors to NIC */
for (i = 0; i < buffer->entries; i++) {
index = buffer->index + i;
- dma_addr = buffer->dma_addr + (i * 4096);
+ dma_addr = buffer->dma_addr + (i * EFX_BUF_SIZE);
netif_dbg(efx, probe, efx->net_dev,
"mapping special buffer %d at %llx\n",
index, (unsigned long long)dma_addr);
diff --git a/drivers/net/ethernet/sfc/nic.h b/drivers/net/ethernet/sfc/nic.h
index 905a187..4f9d18a 100644
--- a/drivers/net/ethernet/sfc/nic.h
+++ b/drivers/net/ethernet/sfc/nic.h
@@ -65,6 +65,11 @@ enum {
#define FALCON_GMAC_LOOPBACKS \
(1 << LOOPBACK_GMAC)
+/* Alignment of PCIe DMA boundaries (4KB) */
+#define EFX_PAGE_SIZE 4096
+/* Size and alignment of buffer table entries (same) */
+#define EFX_BUF_SIZE EFX_PAGE_SIZE
+
/**
* struct falcon_board_type - board operations and type information
* @id: Board type id, as found in NVRAM
diff --git a/drivers/net/ethernet/sfc/tx.c b/drivers/net/ethernet/sfc/tx.c
index 5cb81fa..a096e28 100644
--- a/drivers/net/ethernet/sfc/tx.c
+++ b/drivers/net/ethernet/sfc/tx.c
@@ -110,7 +110,7 @@ efx_max_tx_len(struct efx_nic *efx, dma_addr_t dma_addr)
* little benefit from using descriptors that cross those
* boundaries and we keep things simple by not doing so.
*/
- unsigned len = (~dma_addr & 0xfff) + 1;
+ unsigned len = (~dma_addr & (EFX_PAGE_SIZE - 1)) + 1;
/* Work around hardware bug for unaligned buffers. */
if (EFX_WORKAROUND_5391(efx) && (dma_addr & 0xf))
--
1.7.7.6
--
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.
next prev parent reply other threads:[~2012-02-16 0:45 UTC|newest]
Thread overview: 25+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-02-16 0:42 pull request: sfc-next 2012-02-16 Ben Hutchings
2012-02-16 0:44 ` [PATCH net-next 01/19] sfc: Skip RX end-of-batch work on channels without an RX queue Ben Hutchings
2012-02-16 0:44 ` [PATCH net-next 02/19] sfc: Do not retry hardware probe if it schedules a reset Ben Hutchings
2012-02-16 0:45 ` Ben Hutchings [this message]
2012-02-16 0:45 ` [PATCH net-next 04/19] sfc: Warn if unable to create MTDs Ben Hutchings
2012-02-16 0:46 ` [PATCH net-next 05/19] sfc: Add support for configuring RX unicast/multicast default filters Ben Hutchings
2012-02-16 0:46 ` [PATCH net-next 06/19] sfc: Add support for TX MAC filters Ben Hutchings
2012-02-16 0:47 ` [PATCH net-next 07/19] sfc: Correct MAC filter bitfield definitions Ben Hutchings
2012-02-16 0:47 ` [PATCH net-next 08/19] sfc: Generalise driver event generation Ben Hutchings
2012-02-16 0:47 ` [PATCH net-next 09/19] sfc: Generate RX fill events based on RX queues, not channels Ben Hutchings
2012-02-16 0:48 ` [PATCH net-next 10/19] sfc: Leave interrupts and event queues enabled whenever we can Ben Hutchings
2012-02-16 0:48 ` [PATCH net-next 11/19] sfc: Use proper function to test for RX channel in efx_poll() Ben Hutchings
2012-02-16 0:48 ` [PATCH net-next 12/19] sfc: Generalise event generation to cover VF-owned event queues Ben Hutchings
2012-02-16 0:49 ` [PATCH net-next 13/19] sfc: Disable flow control during flushes Ben Hutchings
2012-02-16 0:49 ` [PATCH net-next 14/19] sfc: Make buffer table indices and counts consistently unsigned Ben Hutchings
2012-02-16 0:50 ` [PATCH net-next 15/19] sfc: Make all CPU/IRQ/channel/queue counts unsigned Ben Hutchings
2012-02-16 0:50 ` [PATCH net-next 16/19] sfc: Add support for 'extra' channel types Ben Hutchings
2012-02-16 0:51 ` [PATCH net-next 17/19] sfc: Pass NIC structure into efx_wanted_parallelism() Ben Hutchings
2012-02-16 0:52 ` [PATCH net-next 18/19] sfc: Allocate SRAM between buffer table and descriptor caches at init time Ben Hutchings
2012-02-16 0:52 ` [PATCH net-next 19/19] sfc: Add SR-IOV back-end support for SFC9000 family Ben Hutchings
2012-02-16 1:18 ` John Fastabend
2012-02-16 1:57 ` Ben Hutchings
2012-02-21 19:52 ` John Fastabend
2012-02-21 20:24 ` Ben Hutchings
2012-02-16 22:08 ` pull request: sfc-next 2012-02-16 David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1329353111.2565.29.camel@bwh-desktop \
--to=bhutchings@solarflare.com \
--cc=davem@davemloft.net \
--cc=linux-net-drivers@solarflare.com \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).