[PATCHv2 net-next 1/2] mdio: Export mdio.h to userland

[PATCHv2 net-next 1/2] mdio: Export mdio.h to userland

[Ben Hutchings]

The ID packing definitions are needed by userland and the register
definitions may also be useful there.

Do not export mdio_phy_id_{is_c45,prtad,devad}() as the use of bool is
problematic and it's not that useful to export only a subset of these.

Do not export MDIO_SUPPORTS_{C22,C45} directly; these flags are only
exposed to userland through struct ethtool_cmd so they should be
defined alongside that with appropriate names.

Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
---
 include/linux/Kbuild |    1 +
 include/linux/mdio.h |    9 ++++-----
 2 files changed, 5 insertions(+), 5 deletions(-)

diff --git a/include/linux/Kbuild b/include/linux/Kbuild
index c94e717..4b0b7ed 100644
--- a/include/linux/Kbuild
+++ b/include/linux/Kbuild
@@ -238,6 +238,7 @@ header-y += magic.h
 header-y += major.h
 header-y += map_to_7segment.h
 header-y += matroxfb.h
+header-y += mdio.h
 header-y += media.h
 header-y += mempolicy.h
 header-y += meye.h
diff --git a/include/linux/mdio.h b/include/linux/mdio.h
index b1494ac..dec1e87 100644
--- a/include/linux/mdio.h
+++ b/include/linux/mdio.h
@@ -273,6 +273,8 @@ static inline __u16 mdio_phy_id_c45(int prtad, int devad)
 	return MDIO_PHY_ID_C45 | (prtad << 5) | devad;
 }
 
+#ifdef __KERNEL__ 
+
 static inline bool mdio_phy_id_is_c45(int phy_id)
 {
 	return (phy_id & MDIO_PHY_ID_C45) && !(phy_id & ~MDIO_PHY_ID_C45_MASK);
@@ -288,11 +290,6 @@ static inline __u16 mdio_phy_id_devad(int phy_id)
 	return phy_id & MDIO_PHY_ID_DEVAD;
 }
 
-#define MDIO_SUPPORTS_C22		1
-#define MDIO_SUPPORTS_C45		2
-
-#ifdef __KERNEL__ 
-
 /**
  * struct mdio_if_info - Ethernet controller MDIO interface
  * @prtad: PRTAD of the PHY (%MDIO_PRTAD_NONE if not present/unknown)
@@ -321,6 +318,8 @@ struct mdio_if_info {
 
 #define MDIO_PRTAD_NONE			(-1)
 #define MDIO_DEVAD_NONE			(-1)
+#define MDIO_SUPPORTS_C22		1
+#define MDIO_SUPPORTS_C45		2
 #define MDIO_EMULATE_C22		4
 
 struct ethtool_cmd;
-- 
1.7.7.6



-- 
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.

[PATCH net-next 2/2] ethtool, mdio, mii: Specify MDIO information fields in struct ethtool_cmd

[Ben Hutchings]

Add comments for ethtool_cmd::phy_address and
ethtool_cmd::mdio_support, and definitions of the flags currently
used in mdio_support.

In the mdio library, assert that its own flags continue to match those
in the ethtool interface.

In the mii library, use the ethtool flag definition and stop
including <linux/mdio.h>.

Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
---
 drivers/net/mdio.c      |    3 +++
 drivers/net/mii.c       |    4 ++--
 include/linux/ethtool.h |   23 +++++++++++++++++++++--
 3 files changed, 26 insertions(+), 4 deletions(-)

diff --git a/drivers/net/mdio.c b/drivers/net/mdio.c
index 16fbb11..8403316 100644
--- a/drivers/net/mdio.c
+++ b/drivers/net/mdio.c
@@ -190,6 +190,9 @@ void mdio45_ethtool_gset_npage(const struct mdio_if_info *mdio,
 	int reg;
 	u32 speed;
 
+	BUILD_BUG_ON(MDIO_SUPPORTS_C22 != ETH_MDIO_SUPPORTS_C22);
+	BUILD_BUG_ON(MDIO_SUPPORTS_C45 != ETH_MDIO_SUPPORTS_C45);
+
 	ecmd->transceiver = XCVR_INTERNAL;
 	ecmd->phy_address = mdio->prtad;
 	ecmd->mdio_support =
diff --git a/drivers/net/mii.c b/drivers/net/mii.c
index c70c233..4a99c39 100644
--- a/drivers/net/mii.c
+++ b/drivers/net/mii.c
@@ -31,7 +31,7 @@
 #include <linux/module.h>
 #include <linux/netdevice.h>
 #include <linux/ethtool.h>
-#include <linux/mdio.h>
+#include <linux/mii.h>
 
 static u32 mii_get_an(struct mii_if_info *mii, u16 addr)
 {
@@ -74,7 +74,7 @@ int mii_ethtool_gset(struct mii_if_info *mii, struct ethtool_cmd *ecmd)
 
 	/* this isn't fully supported at higher layers */
 	ecmd->phy_address = mii->phy_id;
-	ecmd->mdio_support = MDIO_SUPPORTS_C22;
+	ecmd->mdio_support = ETH_MDIO_SUPPORTS_C22;
 
 	ecmd->advertising = ADVERTISED_TP | ADVERTISED_MII;
 
diff --git a/include/linux/ethtool.h b/include/linux/ethtool.h
index da5b2de..e1d9e0e 100644
--- a/include/linux/ethtool.h
+++ b/include/linux/ethtool.h
@@ -30,10 +30,15 @@ struct ethtool_cmd {
 				 * access it */
 	__u8	duplex;		/* Duplex, half or full */
 	__u8	port;		/* Which connector port */
-	__u8	phy_address;
+	__u8	phy_address;	/* MDIO PHY address (PRTAD for clause 45).
+				 * May be read-only or read-write
+				 * depending on the driver.
+				 */
 	__u8	transceiver;	/* Which transceiver to use */
 	__u8	autoneg;	/* Enable or disable autonegotiation */
-	__u8	mdio_support;
+	__u8	mdio_support;	/* MDIO protocols supported.  Read-only.
+				 * Not set by all drivers.
+				 */
 	__u32	maxtxpkt;	/* Tx pkts before generating tx int */
 	__u32	maxrxpkt;	/* Rx pkts before generating rx int */
 	__u16	speed_hi;       /* The forced speed (upper
@@ -59,6 +64,20 @@ static inline __u32 ethtool_cmd_speed(const struct ethtool_cmd *ep)
 	return (ep->speed_hi << 16) | ep->speed;
 }
 
+/* Device supports clause 22 register access to PHY or peripherals
+ * using the interface defined in <linux/mii.h>.  This should not be
+ * set if there are known to be no such peripherals present or if
+ * the driver only emulates clause 22 registers for compatibility.
+ */
+#define ETH_MDIO_SUPPORTS_C22	1
+
+/* Device supports clause 45 register access to PHY or peripherals
+ * using the interface defined in <linux/mii.h> and <linux/mdio.h>.
+ * This should not be set if there are known to be no such peripherals
+ * present.
+ */
+#define ETH_MDIO_SUPPORTS_C45	2
+
 #define ETHTOOL_FWVERS_LEN	32
 #define ETHTOOL_BUSINFO_LEN	32
 /* these strings are set to whatever the driver author decides... */
-- 
1.7.7.6


-- 
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.

Re: [PATCH net-next 2/2] ethtool, mdio, mii: Specify MDIO information fields in struct ethtool_cmd

[David Miller]

From: Ben Hutchings <bhutchings@solarflare.com>
Date: Thu, 1 Mar 2012 00:26:22 +0000

> Add comments for ethtool_cmd::phy_address and
> ethtool_cmd::mdio_support, and definitions of the flags currently
> used in mdio_support.
> 
> In the mdio library, assert that its own flags continue to match those
> in the ethtool interface.
> 
> In the mii library, use the ethtool flag definition and stop
> including <linux/mdio.h>.
> 
> Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>

Applied, thanks Ben.

Re: [PATCHv2 net-next 1/2] mdio: Export mdio.h to userland

[David Miller]

From: Ben Hutchings <bhutchings@solarflare.com>
Date: Thu, 1 Mar 2012 00:23:27 +0000

> The ID packing definitions are needed by userland and the register
> definitions may also be useful there.
> 
> Do not export mdio_phy_id_{is_c45,prtad,devad}() as the use of bool is
> problematic and it's not that useful to export only a subset of these.
> 
> Do not export MDIO_SUPPORTS_{C22,C45} directly; these flags are only
> exposed to userland through struct ethtool_cmd so they should be
> defined alongside that with appropriate names.
> 
> Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>

Applied, although I had to fixup trailing whitespace:

> +#ifdef __KERNEL__ 

here.