From mboxrd@z Thu Jan 1 00:00:00 1970 From: Nicolas Dichtel Subject: [PATCH net-next v3 0/1] Add support of ECMPv6 Date: Wed, 19 Sep 2012 11:18:23 +0200 Message-ID: <1348046304-4156-1-git-send-email-nicolas.dichtel@6wind.com> References: <1347609548-14494-1-git-send-email-nicolas.dichtel@6wind.com> Cc: bernat@luffy.cx, yoshfuji@linux-ipv6.org To: netdev@vger.kernel.org, davem@davemloft.net Return-path: Received: from 33.106-14-84.ripe.coltfrance.com ([84.14.106.33]:51227 "EHLO proxy.6wind.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1753516Ab2ISJQ0 (ORCPT ); Wed, 19 Sep 2012 05:16:26 -0400 In-Reply-To: <1347609548-14494-1-git-send-email-nicolas.dichtel@6wind.com> Sender: netdev-owner@vger.kernel.org List-ID: Here is a proposal to add the support of ECMPv6. The previous patch from Vincent against iproute2 can be used, but a little other patch is needed too, see http://patchwork.ozlabs.org/patch/183277/ If the kernel patch is approved, I can submit formally the patch for iproute2. Here is an example of a command to add an ECMP route: $ ip -6 route add 3ffe:304:124:2306::/64 \ nexthop via fe80::230:1bff:feb4:e05c dev eth0 \ nexthop via fe80::230:1bff:feb4:dd4f dev eth0 But note that this command is a shortcut and previous patches are not mandatory to set ECMP routes. The following commands can be used too: $ ip -6 route add 3ffe:304:124:2306::/64 via fe80::230:1bff:feb4:dd4f dev eth0 $ ip -6 route append 3ffe:304:124:2306::/64 via fe80::230:1bff:feb4:e05c dev eth0 Here is an example of a dump: $ ip -6 route | grep 3ffe:304:124:2306::/64 3ffe:304:124:2306::/64 via fe80::230:1bff:feb4:dd4f dev eth0 metric 1024 3ffe:304:124:2306::/64 via fe80::230:1bff:feb4:e05c dev eth0 metric 1024 v2: rename CONFIG_IPV6_MULTIPATH_ROUTE to CONFIG_IPV6_MULTIPATH_HASH use flowlabel in the hash function add reference to RFC fix a small identation issue remove "If unsure, say N." from the help of CONFIG_IPV6_MULTIPATH v3: rebase after updating net-next Comments are welcome. Regards, Nicolas