[PATCH 0/8] at91_ether share stats/address setting with macb

[Joachim Eastwood <manabian@gmail.com>]

Patch 1-2 add support for some special at91_ether features to macb address setting code. This will allow us to have one address setting function that can be shared.

Patch 4 removes the at91_ether address set/get code and make use of the exported functions for macb.

Patch 5 remove the at91_ether statistics functions and replace them with equivalent function from macb.

Patch 6 removes an unused member from the at91_ether/macb private struct.

Patch 7 is a clean up of the print outs from at91_ether.

Patch 8 is a misc clean up patch which fixes some comment and style issues.


Most of the code left in at91_ether now deal with configuration and DMA rx/tx which is hard to share with macb since this is specific for the IP block in AT91RM9200.

Next I'll work on adding PHY GPIO interrupt to the macb driver. at91_ether had this functionality before it began using mdio functions from macb.


Joachim Eastwood (8):
  net/macb: check all address registers sets
  net/macb: support reversed hw addr
  net/macb: export macb_set_hwaddr and macb_get_hwaddr
  net/at91_ether: use macb functions for get/set hwaddr
  net/at91_ether: use stat function from macb
  net/at91_ether: drop board_data private struct member
  net/at91_ether: clean up print outs
  net/at91_ether: fix comment and style issues

 drivers/net/ethernet/cadence/at91_ether.c | 289 +++++++-----------------------
 drivers/net/ethernet/cadence/macb.c       |  54 ++++--
 drivers/net/ethernet/cadence/macb.h       |  10 +-
 3 files changed, 109 insertions(+), 244 deletions(-)

-- 
1.8.0