[PATCH net-next v2 2/3] net: phy: bcm7xxx: fix spurious MDIO failures during workaround

[Florian Fainelli <f.fainelli@gmail.com>]

Writing first to the AFE registers, and then the VCO, RCAL, RC_CAL
registers turned out to unveil some spurious MDIO read/write failures
which would make the workaround partially applied. The fix is to write
first to the VCO, RCAL, RC_CAL registers, and then write to the AFE
registers.

Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
---
- Use named registers constants 

 drivers/net/phy/bcm7xxx.c | 30 +++++++++++++++---------------
 1 file changed, 15 insertions(+), 15 deletions(-)

diff --git a/drivers/net/phy/bcm7xxx.c b/drivers/net/phy/bcm7xxx.c
index 314194179168..5991168bcbef 100644
--- a/drivers/net/phy/bcm7xxx.c
+++ b/drivers/net/phy/bcm7xxx.c
@@ -103,21 +103,6 @@ static void phy_write_misc(struct phy_device *phydev,
 
 static int bcm7xxx_28nm_afe_config_init(struct phy_device *phydev)
 {
-	/* write AFE_RXCONFIG_0 */
-	phy_write_misc(phydev, AFE_RXCONFIG_0, 0xeb19);
-
-	/* write AFE_RXCONFIG_1 */
-	phy_write_misc(phydev, AFE_RXCONFIG_1, 0x9a3f);
-
-	/* write AFE_RX_LP_COUNTER */
-	phy_write_misc(phydev, AFE_RX_LP_COUNTER, 0x7fc7);
-
-	/* write AFE_HPF_TRIM_OTHERS */
-	phy_write_misc(phydev, AFE_HPF_TRIM_OTHERS, 0x000b);
-
-	/* write AFTE_TX_CONFIG */
-	phy_write_misc(phydev, AFE_TX_CONFIG, 0x0800);
-
 	/* Increase VCO range to prevent unlocking problem of PLL at low
 	 * temp
 	 */
@@ -143,6 +128,21 @@ static int bcm7xxx_28nm_afe_config_init(struct phy_device *phydev)
 	/* Disable Reset R_CAL/RC_CAL Engine */
 	phy_write_exp(phydev, CORE_EXPB0, 0x0000);
 
+	/* write AFE_RXCONFIG_0 */
+	phy_write_misc(phydev, AFE_RXCONFIG_0, 0xeb19);
+
+	/* write AFE_RXCONFIG_1 */
+	phy_write_misc(phydev, AFE_RXCONFIG_1, 0x9a3f);
+
+	/* write AFE_RX_LP_COUNTER */
+	phy_write_misc(phydev, AFE_RX_LP_COUNTER, 0x7fc7);
+
+	/* write AFE_HPF_TRIM_OTHERS */
+	phy_write_misc(phydev, AFE_HPF_TRIM_OTHERS, 0x000b);
+
+	/* write AFTE_TX_CONFIG */
+	phy_write_misc(phydev, AFE_TX_CONFIG, 0x0800);
+
 	return 0;
 }
 
-- 
1.8.3.2