[PATCH v3] bonding: Inactive slaves should keep inactive flag's value

[Zheng Li <zheng.x.li@oracle.com>]

bond_open is not setting the inactive flag correctly for some modes (alb and
tlb), resulting in error behavior if the bond has been administratively set
down and then back up. This effect should not occur when slaves are added while
the bond is up; it's something that only happens after a down/up bounce of the
bond.

For example, in bond tlb or alb mode, domu send some ARP request which go out
from dom0 bond's active slave, then the ARP broadcast request packets go back to
inactive slave from switch, because the inactive slave's inactive flag is zero,
kernel will receive the packets and pass them to bridge that cause dom0's bridge
map domu's MAC address to port of bond, bridge should map domu's MAC to port of
vif.

Signed-off-by: Zheng Li <zheng.x.li@oracle.com>
Signed-off-by: Jay Vosburgh <j.vosburgh@gmail.com>
---
 drivers/net/bonding/bond_main.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/net/bonding/bond_main.c b/drivers/net/bonding/bond_main.c
index e5628fc..b42758f 100644
--- a/drivers/net/bonding/bond_main.c
+++ b/drivers/net/bonding/bond_main.c
@@ -3058,7 +3058,7 @@ static int bond_open(struct net_device *bond_dev)
 	if (bond_has_slaves(bond)) {
 		read_lock(&bond->curr_slave_lock);
 		bond_for_each_slave(bond, slave, iter) {
-			if ((bond->params.mode == BOND_MODE_ACTIVEBACKUP)
+			if (USES_PRIMARY(bond->params.mode)
 				&& (slave != bond->curr_active_slave)) {
 				bond_set_slave_inactive_flags(slave,
 							      BOND_SLAVE_NOTIFY_NOW);
-- 
1.7.6.5