[PATCH net-next] net: stmmac: set phy to use polling by default

[PATCH net-next] net: stmmac: set phy to use polling by default

[dinguyen]

From: Dinh Nguyen <dinguyen@altera.com>

mii_irq[] array is never initialized anywhere in the driver, thus mii_irq[]
will always equate to zero. So, for the case where the PHY does not have an
irq, we should use PHY_POLL for that situation.

Signed-off-by: Dinh Nguyen <dinguyen@altera.com>
Tested-by: Vince Bridgers <vbridger@altera.com>
---
 drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c |    7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
index a468eb1..a5b1e1b 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
@@ -205,10 +205,13 @@ int stmmac_mdio_register(struct net_device *ndev)
 	if (new_bus == NULL)
 		return -ENOMEM;
 
-	if (mdio_bus_data->irqs)
+	if (mdio_bus_data->irqs) {
 		irqlist = mdio_bus_data->irqs;
-	else
+	} else {
+		for (addr = 0; addr < PHY_MAX_ADDR; addr++)
+			priv->mii_irq[addr] = PHY_POLL;
 		irqlist = priv->mii_irq;
+	}
 
 #ifdef CONFIG_OF
 	if (priv->device->of_node)
-- 
1.7.9.5

Re: [PATCH net-next] net: stmmac: set phy to use polling by default

[David Miller]

From: <dinguyen@altera.com>
Date: Tue, 29 Apr 2014 12:56:21 -0500

> From: Dinh Nguyen <dinguyen@altera.com>
> 
> mii_irq[] array is never initialized anywhere in the driver, thus mii_irq[]
> will always equate to zero. So, for the case where the PHY does not have an
> irq, we should use PHY_POLL for that situation.
> 
> Signed-off-by: Dinh Nguyen <dinguyen@altera.com>
> Tested-by: Vince Bridgers <vbridger@altera.com>

Applied.