[PATCH net-next 08/13] at86rf230: rework irq_pol setting

[Alexander Aring <alex.aring@gmail.com>]

This patch rework the irq_pol register setting for rising and falling
interrupt settings only. The default behaviour should be rising flag.

Also use IRQ_TYPE_* defines instead of IRQF_* defines. There is no
functionality change but irq_get_trigger_type returns IRQ_TYPE_* defines.

Signed-off-by: Alexander Aring <alex.aring@gmail.com>
---
 drivers/net/ieee802154/at86rf230.c | 9 +++------
 1 file changed, 3 insertions(+), 6 deletions(-)

diff --git a/drivers/net/ieee802154/at86rf230.c b/drivers/net/ieee802154/at86rf230.c
index 35088a8..4ac7c4b 100644
--- a/drivers/net/ieee802154/at86rf230.c
+++ b/drivers/net/ieee802154/at86rf230.c
@@ -1278,7 +1278,7 @@ static struct at86rf2xx_chip_data at86rf212_data = {
 
 static int at86rf230_hw_init(struct at86rf230_local *lp)
 {
-	int rc, irq_pol, irq_type;
+	int rc, irq_pol, irq_type = IRQ_ACTIVE_HIGH;
 	unsigned int dvdd;
 	u8 csma_seed[2];
 
@@ -1287,11 +1287,8 @@ static int at86rf230_hw_init(struct at86rf230_local *lp)
 		return rc;
 
 	irq_type = irq_get_trigger_type(lp->spi->irq);
-	/* configure irq polarity, defaults to high active */
-	if (irq_type & (IRQF_TRIGGER_FALLING | IRQF_TRIGGER_LOW))
-		irq_pol = IRQ_ACTIVE_LOW;
-	else
-		irq_pol = IRQ_ACTIVE_HIGH;
+	if (irq_type == IRQ_TYPE_EDGE_FALLING)
+		irq_type = IRQ_ACTIVE_LOW;
 
 	rc = at86rf230_write_subreg(lp, SR_IRQ_POLARITY, irq_pol);
 	if (rc)
-- 
2.0.1