From: Florian Fainelli <f.fainelli@gmail.com>
To: netdev@vger.kernel.org
Cc: davem@davemloft.net, Florian Fainelli <f.fainelli@gmail.com>
Subject: [PATCH net-next 04/11] net: bcmgenet: add suspend/resume callbacks
Date: Thu, 10 Jul 2014 15:46:17 -0700 [thread overview]
Message-ID: <1405032384-24006-5-git-send-email-f.fainelli@gmail.com> (raw)
In-Reply-To: <1405032384-24006-1-git-send-email-f.fainelli@gmail.com>
Implement suspend/resume callbacks in the GENET driver. This makes sure
that we de-initialize and re-initialize the hardware correctly before
entering suspend and when resuming.
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
---
drivers/net/ethernet/broadcom/genet/bcmgenet.c | 95 ++++++++++++++++++++++++++
1 file changed, 95 insertions(+)
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index 4d586f0d7d63..f810cddbcf58 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -2594,6 +2594,100 @@ static int bcmgenet_remove(struct platform_device *pdev)
return 0;
}
+#ifdef CONFIG_PM_SLEEP
+static int bcmgenet_suspend(struct device *d)
+{
+ struct net_device *dev = dev_get_drvdata(d);
+ struct bcmgenet_priv *priv = netdev_priv(dev);
+ int ret;
+
+ if (!netif_running(dev))
+ return 0;
+
+ bcmgenet_netif_stop(dev);
+
+ netif_device_detach(dev);
+
+ /* Disable MAC receive */
+ umac_enable_set(priv, CMD_RX_EN, 0);
+
+ ret = bcmgenet_dma_teardown(priv);
+ if (ret)
+ return ret;
+
+ /* Disable MAC transmit. TX DMA disabled have to done before this */
+ umac_enable_set(priv, CMD_TX_EN, 0);
+
+ /* tx reclaim */
+ bcmgenet_tx_reclaim_all(dev);
+ bcmgenet_fini_dma(priv);
+
+ /* Turn off the clocks */
+ clk_disable_unprepare(priv->clk);
+
+ return 0;
+}
+
+static int bcmgenet_resume(struct device *d)
+{
+ struct net_device *dev = dev_get_drvdata(d);
+ struct bcmgenet_priv *priv = netdev_priv(dev);
+ unsigned long dma_ctrl;
+ int ret;
+ u32 reg;
+
+ if (!netif_running(dev))
+ return 0;
+
+ /* Turn on the clock */
+ ret = clk_prepare_enable(priv->clk);
+ if (ret)
+ return ret;
+
+ bcmgenet_umac_reset(priv);
+
+ ret = init_umac(priv);
+ if (ret)
+ goto out_clk_disable;
+
+ /* disable ethernet MAC while updating its registers */
+ umac_enable_set(priv, CMD_TX_EN | CMD_RX_EN, 0);
+
+ bcmgenet_set_hw_addr(priv, dev->dev_addr);
+
+ if (phy_is_internal(priv->phydev)) {
+ reg = bcmgenet_ext_readl(priv, EXT_EXT_PWR_MGMT);
+ reg |= EXT_ENERGY_DET_MASK;
+ bcmgenet_ext_writel(priv, reg, EXT_EXT_PWR_MGMT);
+ }
+
+ /* Disable RX/TX DMA and flush TX queues */
+ dma_ctrl = bcmgenet_dma_disable(priv);
+
+ /* Reinitialize TDMA and RDMA and SW housekeeping */
+ ret = bcmgenet_init_dma(priv);
+ if (ret) {
+ netdev_err(dev, "failed to initialize DMA\n");
+ goto out_clk_disable;
+ }
+
+ /* Always enable ring 16 - descriptor ring */
+ bcmgenet_enable_dma(priv, dma_ctrl);
+
+ netif_device_attach(dev);
+
+ bcmgenet_netif_start(dev);
+
+ return 0;
+
+out_clk_disable:
+ clk_disable_unprepare(priv->clk);
+ return ret;
+}
+#endif /* CONFIG_PM_SLEEP */
+
+static SIMPLE_DEV_PM_OPS(bcmgenet_pm_ops, bcmgenet_suspend, bcmgenet_resume);
+
static struct platform_driver bcmgenet_driver = {
.probe = bcmgenet_probe,
.remove = bcmgenet_remove,
@@ -2601,6 +2695,7 @@ static struct platform_driver bcmgenet_driver = {
.name = "bcmgenet",
.owner = THIS_MODULE,
.of_match_table = bcmgenet_match,
+ .pm = &bcmgenet_pm_ops,
},
};
module_platform_driver(bcmgenet_driver);
--
1.9.1
next prev parent reply other threads:[~2014-07-10 22:46 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-07-10 22:46 [PATCH net-next 00/11] net: bcmgenet: PM and Wake-on-LAN Florian Fainelli
2014-07-10 22:46 ` [PATCH net-next 01/11] net: bcmgenet: remove wol_enabled conditional code Florian Fainelli
2014-07-10 22:46 ` [PATCH net-next 02/11] net: bcmgenet: add umac_enable_set helper Florian Fainelli
2014-07-11 20:39 ` David Miller
2014-07-10 22:46 ` [PATCH net-next 03/11] net: bcmgenet: modularize bcmgenet_{open,close} Florian Fainelli
2014-07-10 22:46 ` Florian Fainelli [this message]
2014-07-10 22:46 ` [PATCH net-next 05/11] net: bcmgenet: request Wake-on-LAN interrupt Florian Fainelli
2014-07-11 20:41 ` David Miller
2014-07-10 22:46 ` [PATCH net-next 06/11] net: bcmgenet: add Wake-on-LAN support code Florian Fainelli
2014-07-10 22:46 ` [PATCH net-next 07/11] net: bcmgenet: handle GENET_POWER_WOL_MAGIC Florian Fainelli
2014-07-10 22:46 ` [PATCH net-next 08/11] net: bcmgenet: handle UMAC_IRQ_MPD_R interrupt bit Florian Fainelli
2014-07-10 22:46 ` [PATCH net-next 09/11] net: bcmgenet: fix bcmgenet_wol_resume Florian Fainelli
2014-07-10 22:46 ` [PATCH net-next 10/11] net: bcmgenet: suspend and resume from Wake-on-LAN Florian Fainelli
2014-07-10 22:46 ` [PATCH net-next 11/11] net: bcmgenet: hook ethtool set/get_wol operations Florian Fainelli
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1405032384-24006-5-git-send-email-f.fainelli@gmail.com \
--to=f.fainelli@gmail.com \
--cc=davem@davemloft.net \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).