netdev.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Johannes Berg <johannes-cdvu00un1VgdHxzADdlk8Q@public.gmane.org>
To: Linus Torvalds
	<torvalds-de/tnXTf+JLsfHDXvbKv3WD2FQJk+8+b@public.gmane.org>,
	Larry Finger
	<Larry.Finger-tQ5ms3gMjBLk1uMJSBkQmQ@public.gmane.org>,
	Chaoming Li <chaoming_li-kXabqFNEczNtrwSWzY7KCg@public.gmane.org>,
	Kalle Valo <kvalo-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
Cc: David Miller <davem-fT/PcQaiUtIeIZ0/mPfg9Q@public.gmane.org>,
	Linux Wireless List
	<linux-wireless-u79uwXL29TY76Z2rM5mHXA@public.gmane.org>,
	Network Development
	<netdev-u79uwXL29TY76Z2rM5mHXA@public.gmane.org>
Subject: Re: WARNING at net/mac80211/rate.c:513 ieee80211_get_tx_rates [mac80211]
Date: Thu, 28 Jan 2016 23:12:35 +0100	[thread overview]
Message-ID: <1454019155.2332.15.camel@sipsolutions.net> (raw)
In-Reply-To: <CA+55aFzF0gWfvmE+6ZcHmjnO4xp-oVAQ5SWxYJhOzns2ocgCsw-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org> (sfid-20160128_230454_551008_3AE61B48)

On Thu, 2016-01-28 at 14:04 -0800, Linus Torvalds wrote:
> 
> Well, it "makes a difference" in the sense that the warning goes
> away.
> But it doesn't make things work. In fact, it might be making things
> worse.

Heh, ok.

> Because with that patch, the wireless still authenticates and
> associates, but then it doesn't even get an IP address, so now even
> dhcp doesn't work. Of course, I was surprised that it worked last
> time, and I'm not 100% sure it did work consistently. I'll re-test
> without the patch, just to make sure, but it doesn't really seem to
> improve on anything.
> 

It makes some sense, here's some speculation:

VHT rates are MCS 0-9. If the rate scaling decides to use only VHT
MCSes with a VHT-capable peer, then it stands to reason it might still
start at 0, but forget to set the VHT_MCS flag, so it would really use
rate index 0 from the table, which is 6 MBps. Then, it would see that
"working" (since it's not the right thing) and scale up until it hits
MCS 8 or 9, which is no longer a valid rate (those are only 0-7).

Since the suggested changes make it worse, we can assume that this is
not the only place where VHT is simply completely broken, and fixing
VHT here will instead uncover a bug elsewhere, that was previously not
happening because we never got to real VHT rates.

Your best workaround may just be to ignore VHT for now - clearly it's
broken so using "just" HT (which is likely not that much of a penalty
anyway since you're apparently not using 80 MHz) will be much better.

Go into

_rtl_init_hw_vht_capab()

and just remove or stub out the entire contents of that (or you could
just remove the "vht_supported=true" if you feel like it.)

That should get it to HT only, which is likely tested and working
better.

johannes
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

  parent reply	other threads:[~2016-01-28 22:12 UTC|newest]

Thread overview: 17+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2016-01-28  5:34 WARNING at net/mac80211/rate.c:513 ieee80211_get_tx_rates [mac80211] Linus Torvalds
     [not found] ` <CA+55aFxe22iWok6UojY=hCoG2k1wNpJ9CfQ0b+STSxq67tb86Q-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2016-01-28 12:13   ` Johannes Berg
     [not found]     ` <1453983185.2217.12.camel-cdvu00un1VgdHxzADdlk8Q@public.gmane.org>
2016-01-28 19:01       ` Linus Torvalds
2016-01-28 20:40         ` Johannes Berg
     [not found]           ` <1454013625.2332.9.camel-cdvu00un1VgdHxzADdlk8Q@public.gmane.org>
2016-01-28 21:44             ` Linus Torvalds
2016-01-28 22:04               ` Linus Torvalds
     [not found]                 ` <CA+55aFzF0gWfvmE+6ZcHmjnO4xp-oVAQ5SWxYJhOzns2ocgCsw-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2016-01-28 22:12                   ` Johannes Berg [this message]
2016-01-28 23:01                     ` Linus Torvalds
2016-01-29  1:54                       ` Larry Finger
     [not found]                         ` <56AAC66C.1080800-tQ5ms3gMjBLk1uMJSBkQmQ@public.gmane.org>
2016-01-29  4:19                           ` Linus Torvalds
2016-01-29  8:33                           ` Johannes Berg
     [not found]                             ` <CAP71bdVZzUUNwP3py_m1pwU21qMKth=0BmMfLuUb7=B-1840zg@mail.gmail.com>
     [not found]                               ` <CAP71bdVZzUUNwP3py_m1pwU21qMKth=0BmMfLuUb7=B-1840zg-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2016-01-29 16:15                                 ` Johannes Berg
2016-01-29 16:54                                   ` Larry Finger
     [not found]                                   ` <1454084146.2800.0.camel-cdvu00un1VgdHxzADdlk8Q@public.gmane.org>
2016-01-29 17:54                                     ` Larry Finger
     [not found]                                       ` <56ABA73C.1060504-tQ5ms3gMjBLk1uMJSBkQmQ@public.gmane.org>
2016-01-29 18:39                                         ` Linus Torvalds
     [not found]                                           ` <CA+55aFysqqp-BCZs1ue6_1tE=h9SOUZTH_o7TwGbsaBnaFvXGA-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2016-01-29 19:42                                             ` Larry Finger
     [not found]                                               ` <56ABC0BC.9010202-tQ5ms3gMjBLk1uMJSBkQmQ@public.gmane.org>
2016-01-29 20:04                                                 ` Linus Torvalds

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1454019155.2332.15.camel@sipsolutions.net \
    --to=johannes-cdvu00un1vgdhxzaddlk8q@public.gmane.org \
    --cc=Larry.Finger-tQ5ms3gMjBLk1uMJSBkQmQ@public.gmane.org \
    --cc=chaoming_li-kXabqFNEczNtrwSWzY7KCg@public.gmane.org \
    --cc=davem-fT/PcQaiUtIeIZ0/mPfg9Q@public.gmane.org \
    --cc=kvalo-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org \
    --cc=linux-wireless-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    --cc=netdev-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
    --cc=torvalds-de/tnXTf+JLsfHDXvbKv3WD2FQJk+8+b@public.gmane.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).