Re: GENET and UNIMAC MDIO probe issue?

[Stefan Wahren <stefan.wahren@i2se.com>]

Hi Maxime,

Am 22.10.21 um 16:33 schrieb Maxime Ripard:
> Hi Florian, Doug,
>
> I'm currently trying to make the RaspberryPi CM4 IO board probe its
> ethernet controller, and it looks like genet doesn't manage to find its
> PHY and errors out with:
>
> [    3.240435] libphy: Fixed MDIO Bus: probed
> [    3.248849] bcmgenet fd580000.ethernet: GENET 5.0 EPHY: 0x0000
> [    3.259118] libphy: bcmgenet MII bus: probed
> [    3.278420] mdio_bus unimac-mdio--19: MDIO device at address 1 is missing.
> [    3.285661] unimac-mdio unimac-mdio.-19: Broadcom UniMAC MDIO bus
>
> ....
>
> [   13.082281] could not attach to PHY
> [   13.089762] bcmgenet fd580000.ethernet eth0: failed to connect to PHY
> [   74.739621] could not attach to PHY
> [   74.746492] bcmgenet fd580000.ethernet eth0: failed to connect to PHY
>
> Here's the full boot log:
> https://pastebin.com/8RhuezSn

looks like you are using the vendor DTB, please use the upstream DTB
from linux-next:

bcm2711-rpi-cm4-io.dtb

>
> It looks like it's related to the following bugzilla entry:
> https://bugzilla.kernel.org/show_bug.cgi?id=213485
>
> However, that commit has been merged for a while apparently, and even
> next-20211022 shows that behavior, both with the drivers built-in or as
> modules. The other suggested fix to set probe_type to
> PROBE_FORCE_SYNCHRONOUS doesn't seem to fix it either.
>
> Maxime