From: Subash Abhinov Kasiviswanathan <subashab@codeaurora.org>
To: davem@davemloft.net, netdev@vger.kernel.org, lkp@intel.com,
edumazet@google.com
Cc: Subash Abhinov Kasiviswanathan <subashab@codeaurora.org>
Subject: [PATCH net-next v3 RESEND 06/10] net: qualcomm: rmnet: Define the MAPv4 packet formats
Date: Sun, 7 Jan 2018 11:36:36 -0700 [thread overview]
Message-ID: <1515350200-29472-7-git-send-email-subashab@codeaurora.org> (raw)
In-Reply-To: <1515350200-29472-1-git-send-email-subashab@codeaurora.org>
The MAPv4 packet format adds support for RX / TX checksum offload.
For a bi-directional UDP stream at a rate of 570 / 146 Mbps, roughly
10% CPU cycles are saved.
For receive path, there is a checksum trailer appended to the end of
the MAP packet. The valid field indicates if hardware has computed
the checksum. csum_start_offset indicates the offset from the start
of the IP header from which hardware has computed checksum.
csum_length is the number of bytes over which the checksum was
computed and the resulting value is csum_value.
In the transmit path, a header is appended between the end of the MAP
header and the start of the IP packet. csum_start_offset is the offset
in bytes from which hardware will compute the checksum if the
csum_enabled bit is set. udp_ip4_ind indicates if the checksum
value of 0 is valid or not. csum_insert_offset is the offset from the
csum_start_offset where hardware will insert the computed checksum.
The use of this additional packet format for checksum offload is
explained in subsequent patches.
Signed-off-by: Subash Abhinov Kasiviswanathan <subashab@codeaurora.org>
---
drivers/net/ethernet/qualcomm/rmnet/rmnet_map.h | 16 ++++++++++++++++
drivers/net/ethernet/qualcomm/rmnet/rmnet_private.h | 2 ++
2 files changed, 18 insertions(+)
diff --git a/drivers/net/ethernet/qualcomm/rmnet/rmnet_map.h b/drivers/net/ethernet/qualcomm/rmnet/rmnet_map.h
index ef0eff2..50c50cd 100644
--- a/drivers/net/ethernet/qualcomm/rmnet/rmnet_map.h
+++ b/drivers/net/ethernet/qualcomm/rmnet/rmnet_map.h
@@ -47,6 +47,22 @@ struct rmnet_map_header {
u16 pkt_len;
} __aligned(1);
+struct rmnet_map_dl_csum_trailer {
+ u8 reserved1;
+ u8 valid:1;
+ u8 reserved2:7;
+ u16 csum_start_offset;
+ u16 csum_length;
+ __be16 csum_value;
+} __aligned(1);
+
+struct rmnet_map_ul_csum_header {
+ __be16 csum_start_offset;
+ u16 csum_insert_offset:14;
+ u16 udp_ip4_ind:1;
+ u16 csum_enabled:1;
+} __aligned(1);
+
#define RMNET_MAP_GET_MUX_ID(Y) (((struct rmnet_map_header *) \
(Y)->data)->mux_id)
#define RMNET_MAP_GET_CD_BIT(Y) (((struct rmnet_map_header *) \
diff --git a/drivers/net/ethernet/qualcomm/rmnet/rmnet_private.h b/drivers/net/ethernet/qualcomm/rmnet/rmnet_private.h
index d214280..de0143e 100644
--- a/drivers/net/ethernet/qualcomm/rmnet/rmnet_private.h
+++ b/drivers/net/ethernet/qualcomm/rmnet/rmnet_private.h
@@ -21,6 +21,8 @@
/* Constants */
#define RMNET_INGRESS_FORMAT_DEAGGREGATION BIT(0)
#define RMNET_INGRESS_FORMAT_MAP_COMMANDS BIT(1)
+#define RMNET_INGRESS_FORMAT_MAP_CKSUMV4 BIT(2)
+#define RMNET_EGRESS_FORMAT_MAP_CKSUMV4 BIT(3)
/* Replace skb->dev to a virtual rmnet device and pass up the stack */
#define RMNET_EPMODE_VND (1)
--
1.9.1
next prev parent reply other threads:[~2018-01-07 18:37 UTC|newest]
Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-01-07 18:36 [PATCH net-next v3 RESEND 00/10] net: qualcomm: rmnet: Enable csum offloads Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 01/10] net: qualcomm: rmnet: Remove redundant check when stamping map header Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 02/10] net: qualcomm: rmnet: Remove invalid condition while stamping mux id Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 03/10] net: qualcomm: rmnet: Remove unused function declaration Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 04/10] net: qualcomm: rmnet: Rename ingress data format to data format Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 05/10] net: qualcomm: rmnet: Set pacing shift Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` Subash Abhinov Kasiviswanathan [this message]
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 07/10] net: qualcomm: rmnet: Add support for RX checksum offload Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 08/10] net: qualcomm: rmnet: Handle command packets with checksum trailer Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 09/10] net: qualcomm: rmnet: Add support for TX checksum offload Subash Abhinov Kasiviswanathan
2018-01-07 18:36 ` [PATCH net-next v3 RESEND 10/10] net: qualcomm: rmnet: Add support for GSO Subash Abhinov Kasiviswanathan
2018-01-08 19:01 ` [PATCH net-next v3 RESEND 00/10] net: qualcomm: rmnet: Enable csum offloads David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1515350200-29472-7-git-send-email-subashab@codeaurora.org \
--to=subashab@codeaurora.org \
--cc=davem@davemloft.net \
--cc=edumazet@google.com \
--cc=lkp@intel.com \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).