From: Ilias Apalodimas <ilias.apalodimas@linaro.org>
To: alexandre.torgue@st.com
Cc: peppe.cavallaro@st.com, davem@davemloft.net,
mcoquelin.stm32@gmail.com, netdev@vger.kernel.org,
joabreu@synopsys.com,
Ilias Apalodimas <ilias.apalodimas@linaro.org>
Subject: [net-next, PATCH] net: stmmac: fix ptp timestamping on Rx on gmac4
Date: Tue, 5 Feb 2019 14:15:20 +0200 [thread overview]
Message-ID: <1549368920-1989-1-git-send-email-ilias.apalodimas@linaro.org> (raw)
The current driver only enables Pdelay_Req and Pdelay_Resp when
HWTSTAMP_FILTER_PTP_V2_EVENT, HWTSTAMP_FILTER_PTP_V1_L4_EVENT or
HWTSTAMP_FILTER_PTP_V2_L4_EVENT is requested. This results in ptp sync on
slave mode to report 'received SYNC without timestamp' when using ptp4l.
Although the hardware can support Sync, Pdelay_Req and Pdelay_resp by
setting bit14 annd bits 17/16 to 01 this leaves Delay_Req timestamps out.
Fix this by enabling all event and general messages timestamps.
This includes SYNC, Follow_Up, Delay_Req, Delay_Resp, Pdelay_Req,
Pdelay_Resp and Pdelay_Resp_Follow_Up messages.
Signed-off-by: Ilias Apalodimas <ilias.apalodimas@linaro.org>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 25 ++++++++---------------
drivers/net/ethernet/stmicro/stmmac/stmmac_ptp.h | 9 ++++++--
2 files changed, 16 insertions(+), 18 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 517555b..effff17 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -597,12 +597,13 @@ static int stmmac_hwtstamp_set(struct net_device *dev, struct ifreq *ifr)
case HWTSTAMP_FILTER_PTP_V1_L4_EVENT:
/* PTP v1, UDP, any kind of event packet */
config.rx_filter = HWTSTAMP_FILTER_PTP_V1_L4_EVENT;
- /* take time stamp for all event messages */
- if (xmac)
- snap_type_sel = PTP_GMAC4_TCR_SNAPTYPSEL_1;
- else
- snap_type_sel = PTP_TCR_SNAPTYPSEL_1;
-
+ /* 'xmac' hardware can support Sync, Pdelay_Req and
+ * Pdelay_resp by setting bit14 and bits17/16 to 01
+ * This leaves Delay_Req timestamps out.
+ * Enable all events *and* general purpose message
+ * timestamping
+ */
+ snap_type_sel = PTP_TCR_SNAPTYPSEL_1;
ptp_over_ipv4_udp = PTP_TCR_TSIPV4ENA;
ptp_over_ipv6_udp = PTP_TCR_TSIPV6ENA;
break;
@@ -633,10 +634,7 @@ static int stmmac_hwtstamp_set(struct net_device *dev, struct ifreq *ifr)
config.rx_filter = HWTSTAMP_FILTER_PTP_V2_L4_EVENT;
ptp_v2 = PTP_TCR_TSVER2ENA;
/* take time stamp for all event messages */
- if (xmac)
- snap_type_sel = PTP_GMAC4_TCR_SNAPTYPSEL_1;
- else
- snap_type_sel = PTP_TCR_SNAPTYPSEL_1;
+ snap_type_sel = PTP_TCR_SNAPTYPSEL_1;
ptp_over_ipv4_udp = PTP_TCR_TSIPV4ENA;
ptp_over_ipv6_udp = PTP_TCR_TSIPV6ENA;
@@ -669,12 +667,7 @@ static int stmmac_hwtstamp_set(struct net_device *dev, struct ifreq *ifr)
/* PTP v2/802.AS1 any layer, any kind of event packet */
config.rx_filter = HWTSTAMP_FILTER_PTP_V2_EVENT;
ptp_v2 = PTP_TCR_TSVER2ENA;
- /* take time stamp for all event messages */
- if (xmac)
- snap_type_sel = PTP_GMAC4_TCR_SNAPTYPSEL_1;
- else
- snap_type_sel = PTP_TCR_SNAPTYPSEL_1;
-
+ snap_type_sel = PTP_TCR_SNAPTYPSEL_1;
ptp_over_ipv4_udp = PTP_TCR_TSIPV4ENA;
ptp_over_ipv6_udp = PTP_TCR_TSIPV6ENA;
ptp_over_ethernet = PTP_TCR_TSIPENA;
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_ptp.h b/drivers/net/ethernet/stmicro/stmmac/stmmac_ptp.h
index ecccf89..e852821 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_ptp.h
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_ptp.h
@@ -59,9 +59,14 @@
#define PTP_TCR_TSEVNTENA BIT(14)
/* Enable Snapshot for Messages Relevant to Master */
#define PTP_TCR_TSMSTRENA BIT(15)
-/* Select PTP packets for Taking Snapshots */
+/* Select PTP packets for Taking Snapshots
+ * On gmac4 specifically:
+ * Enable SYNC, Pdelay_Req, Pdelay_Resp when TSEVNTENA is enabled.
+ * or
+ * Enable SYNC, Follow_Up, Delay_Req, Delay_Resp, Pdelay_Req, Pdelay_Resp,
+ * Pdelay_Resp_Follow_Up if TSEVNTENA is disabled
+ */
#define PTP_TCR_SNAPTYPSEL_1 BIT(16)
-#define PTP_GMAC4_TCR_SNAPTYPSEL_1 GENMASK(17, 16)
/* Enable MAC address for PTP Frame Filtering */
#define PTP_TCR_TSENMACADDR BIT(18)
--
2.7.4
next reply other threads:[~2019-02-05 12:15 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-02-05 12:15 Ilias Apalodimas [this message]
2019-02-06 11:45 ` [net-next, PATCH] net: stmmac: fix ptp timestamping on Rx on gmac4 Jose Abreu
2019-02-06 12:56 ` Alexandre Torgue
2019-02-07 1:28 ` David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1549368920-1989-1-git-send-email-ilias.apalodimas@linaro.org \
--to=ilias.apalodimas@linaro.org \
--cc=alexandre.torgue@st.com \
--cc=davem@davemloft.net \
--cc=joabreu@synopsys.com \
--cc=mcoquelin.stm32@gmail.com \
--cc=netdev@vger.kernel.org \
--cc=peppe.cavallaro@st.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).