[PATCH net] bnxt_en: Drop oversize TX packets to prevent errors.

[Michael Chan <michael.chan@broadcom.com>]

There have been reports of oversize UDP packets being sent to the
driver to be transmitted, causing error conditions.  The issue is
likely caused by the dst of the SKB switching between 'lo' with
64K MTU and the hardware device with a smaller MTU.  Patches are
being proposed by Mahesh Bandewar <maheshb@google.com> to fix the
issue.

In the meantime, add a quick length check in the driver to prevent
the error.  The driver uses the TX packet size as index to look up an
array to setup the TX BD.  The array is large enough to support all MTU
sizes supported by the driver.  The oversize TX packet causes the
driver to index beyond the array and put garbage values into the
TX BD.  Add a simple check to prevent this.

Signed-off-by: Michael Chan <michael.chan@broadcom.com>
---

David, I think this should be queued for stable as well.

 drivers/net/ethernet/broadcom/bnxt/bnxt.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/net/ethernet/broadcom/bnxt/bnxt.c b/drivers/net/ethernet/broadcom/bnxt/bnxt.c
index d95730c..803f799 100644
--- a/drivers/net/ethernet/broadcom/bnxt/bnxt.c
+++ b/drivers/net/ethernet/broadcom/bnxt/bnxt.c
@@ -500,6 +500,12 @@ static netdev_tx_t bnxt_start_xmit(struct sk_buff *skb, struct net_device *dev)
 	}
 
 	length >>= 9;
+	if (unlikely(length >= ARRAY_SIZE(bnxt_lhint_arr))) {
+		dev_warn_ratelimited(&pdev->dev, "Dropped oversize %d bytes TX packet.\n",
+				     skb->len);
+		i = 0;
+		goto tx_dma_error;
+	}
 	flags |= bnxt_lhint_arr[length];
 	txbd->tx_bd_len_flags_type = cpu_to_le32(flags);
 
-- 
2.5.1