From: "Rob Herring (Arm)" <robh@kernel.org>
To: Mohd Ayaan Anwar <mohd.anwar@oss.qualcomm.com>
Cc: Eric Dumazet <edumazet@kernel.org>,
Bjorn Andersson <andersson@kernel.org>,
Maxime Chevallier <maxime.chevallier@bootlin.com>,
Andrew Davis <afd@ti.com>,
"David S. Miller" <davem@davemloft.net>,
Lorenzo Bianconi <lorenzo.bianconi@oss.qualcomm.com>,
Giuseppe Cavallaro <peppe.cavallaro@st.com>,
linux-stm32@st-md-mailman.stormreply.com,
Alexandre Torgue <alexandre.torgue@foss.st.com>,
Maxime Coquelin <mcoquelin.stm32@gmail.com>,
Paolo Abeni <pabeni@redhat.com>,
linux-arm-msm@vger.kernel.org,
Richard Cochran <richardcochran@gmail.com>,
Andrew Lunn <andrew+netdev@lunn.ch>, Andrew Lunn <andrew@lunn.ch>,
Jose Abreu <joabreu@synopsys.com>,
devicetree@vger.kernel.org, Conor Dooley <conor+dt@kernel.org>,
Russell King <linux@armlinux.org.uk>,
netdev@vger.kernel.org, Konrad Dybcio <konradybcio@kernel.org>,
Jakub Kicinski <kuba@kernel.org>,
linux-kernel@vger.kernel.org,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
linux-arm-kernel@lists.infradead.org,
Heiner Kallweit <hkallweit1@gmail.com>
Subject: Re: [PATCH net-next v4 01/10] dt-bindings: net: ti,dp83867: add supply properties
Date: Wed, 18 Nov 2026 12:58:57 -0600 [thread overview]
Message-ID: <179502833706.197934.11325095223476825212.robh@kernel.org> (raw)
In-Reply-To: <20261117-shikra_ethernet-v4-1-c41902e5f2fa@oss.qualcomm.com>
On Tue, 17 Nov 2026 14:15:21 +0530, Mohd Ayaan Anwar wrote:
> The DP83867 PHY has four distinct power supplies:
>
> VDDA2P5 -- 2.5V analog supply
> VDD1P0 -- 1.0V digital supply
> VDDA1P8 -- 1.8V analog supply
> VDDIO -- I/O supply, which can be 3.3V or 2.5V or 1.8V
>
> The DP83867E/IS/CS datasheet (section 8.3) describes two power supply
> configurations - "two-supply" and "three-supply".
>
> 1. Two-Supply Configuration: VDDA2P5 and VDD1P0 connected, and the
> VDDA1P8 pins are left unconnected.
> 2. Three-Supply Configuration: VDDA2P5, VDD1P0 and VDDA1P8 are all
> connected.
>
> VDDIO is a separate fourth supply present in both configurations. The
> datasheet specifies that it can either be 1.8V or 2.5V or 3.3V.
>
> Some embedded board design expose a GPIO-controlled regulator to control
> any one or more of these supplies. Therefore, document all four of the
> available supply properties.
>
> Signed-off-by: Mohd Ayaan Anwar <mohd.anwar@oss.qualcomm.com>
> ---
> v4: This patch was accidentally dropped in v3. It has been re-added
> as-is from v2.
> ---
> Documentation/devicetree/bindings/net/ti,dp83867.yaml | 14 ++++++++++++++
> 1 file changed, 14 insertions(+)
>
Reviewed-by: Rob Herring (Arm) <robh@kernel.org>
next prev parent reply other threads:[~2026-11-18 18:58 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-11-17 8:45 [PATCH net-next v4 00/10] net: stmmac: qcom-ethqos: add Shikra EMAC support Mohd Ayaan Anwar
2026-11-17 8:45 ` [PATCH net-next v4 01/10] dt-bindings: net: ti,dp83867: add supply properties Mohd Ayaan Anwar
2026-11-18 18:58 ` Rob Herring (Arm) [this message]
2026-11-17 8:45 ` [PATCH net-next v4 02/10] net: phy: dp83867: add regulator supply management Mohd Ayaan Anwar
2026-11-17 8:45 ` [PATCH net-next v4 03/10] dt-bindings: net: qcom,ethqos: add qcom,shikra-ethqos compatible Mohd Ayaan Anwar
2026-11-17 8:45 ` [PATCH net-next v4 04/10] net: stmmac: qcom-ethqos: convert ethqos_rgmii_macro_init() to void Mohd Ayaan Anwar
2026-11-17 8:45 ` [PATCH net-next v4 05/10] net: stmmac: qcom-ethqos: add DLL-bypass for PHY-managed RGMII delays Mohd Ayaan Anwar
2026-11-17 8:45 ` [PATCH net-next v4 06/10] net: stmmac: qcom-ethqos: set initial RGMII link clock to lowest speed Mohd Ayaan Anwar
2026-11-18 9:13 ` Lorenzo Bianconi
2026-11-17 8:45 ` [PATCH net-next v4 07/10] net: stmmac: qcom-ethqos: share common GMAC4 address table Mohd Ayaan Anwar
2026-11-17 8:45 ` [PATCH net-next v4 08/10] net: stmmac: qcom-ethqos: add per-platform NOC clock voting Mohd Ayaan Anwar
2026-11-18 9:40 ` Lorenzo Bianconi
2026-11-17 8:45 ` [PATCH net-next v4 09/10] net: stmmac: qcom-ethqos: add Shikra EMAC support Mohd Ayaan Anwar
2026-11-18 9:43 ` Lorenzo Bianconi
2026-11-17 8:45 ` [PATCH net-next v4 10/10] net: stmmac: qcom-ethqos: add QCS615 " Mohd Ayaan Anwar
2026-11-18 9:44 ` Lorenzo Bianconi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=179502833706.197934.11325095223476825212.robh@kernel.org \
--to=robh@kernel.org \
--cc=afd@ti.com \
--cc=alexandre.torgue@foss.st.com \
--cc=andersson@kernel.org \
--cc=andrew+netdev@lunn.ch \
--cc=andrew@lunn.ch \
--cc=conor+dt@kernel.org \
--cc=davem@davemloft.net \
--cc=devicetree@vger.kernel.org \
--cc=edumazet@kernel.org \
--cc=hkallweit1@gmail.com \
--cc=joabreu@synopsys.com \
--cc=konradybcio@kernel.org \
--cc=krzk+dt@kernel.org \
--cc=kuba@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-stm32@st-md-mailman.stormreply.com \
--cc=linux@armlinux.org.uk \
--cc=lorenzo.bianconi@oss.qualcomm.com \
--cc=maxime.chevallier@bootlin.com \
--cc=mcoquelin.stm32@gmail.com \
--cc=mohd.anwar@oss.qualcomm.com \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
--cc=peppe.cavallaro@st.com \
--cc=richardcochran@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox