Regarding 8139 physical identification

Regarding 8139 physical identification

[Krishnakumar. R]

Dear Becker,

I was trying to implement the physical identification
for the 8139 series cards.
For this I need to light the led of the card,
when I need for the purpose of physically identifying it.

After going through the manual, archives 
and writing some code, I have found that
the lights of the led cannot be lighted by
writing values to the "Config1" register's led bits.
Neither does manipulating the values in the 
"CS" registers results in any led being lit.

What is the way to light the led manually.
I understand that according to the configurations
set the led will light in case of the link, tx, rx etc.
But I want to light the led explicitly.
Is there a way to do it ?

Regards,
KK.
-- 
HomePage: http://puggy.symonds.net/~krishnakumar

Re: Regarding 8139 physical identification

[Krishnakumar. R]

Hi,

> Dear Becker,

Sorry for the typo... Please read it as "Hi List"....
But contents are same as I wanted to ask....


>
> I was trying to implement the physical identification
> for the 8139 series cards.
> For this I need to light the led of the card,
> when I need for the purpose of physically identifying it.
>
> After going through the manual, archives
> and writing some code, I have found that
> the lights of the led cannot be lighted by
> writing values to the "Config1" register's led bits.
> Neither does manipulating the values in the
> "CS" registers results in any led being lit.
>
> What is the way to light the led manually.
> I understand that according to the configurations
> set the led will light in case of the link, tx, rx etc.
> But I want to light the led explicitly.
> Is there a way to do it ?
>
> Regards,
> KK.

-- 
HomePage: http://puggy.symonds.net/~krishnakumar