* Re: e1000 not working using 2.6.11
[not found] <17064.41290.461755.920152@ccs.covici.com>
@ 2005-06-11 19:37 ` Adrian Bunk
0 siblings, 0 replies; only message in thread
From: Adrian Bunk @ 2005-06-11 19:37 UTC (permalink / raw)
To: John covici
Cc: linux-kernel, cramerj, john.ronciak, ganesh.venkatesan, netdev
On Thu, Jun 09, 2005 at 04:06:34PM -0400, John covici wrote:
> Hi. I am not getting good results on a box I have which uses an Intel
> Pro gigabit Ethernet driver for its network connection. What happens
> is that I get messages like watchdog xmit timeout and lots of errors
> out of ifconfig. Here is the listpci entry for that card. It works
> under the other OS, so I imagine the hardware is OK.
>
> 0000:01:0b.0 Ethernet controller: Intel Corp. 82540EM Gigabit Ethernet Controller (rev 02)
> Subsystem: Intel Corp.: Unknown device 3013
> Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 19
> Memory at e7000000 (64-bit, non-prefetchable) [size=128K]
> Memory at e7020000 (64-bit, non-prefetchable) [size=64K]
> I/O ports at b400 [size=64]
> Capabilities: [dc] Power Management version 2
> Capabilities: [e4] PCI-X non-bridge device.
> Capabilities: [f0] Message Signalled Interrupts: 64bit+ Queue=0/0 Enable-
>
>
> Any assistance would be appreciated.
Does 2.6.12-rc6 work?
If not, the maintainers of this driver (Cc'ed) might be able to help
you.
> John Covici
cu
Adrian
--
"Is there not promise of rain?" Ling Tan asked suddenly out
of the darkness. There had been need of rain for many days.
"Only a promise," Lao Er said.
Pearl S. Buck - Dragon Seed
^ permalink raw reply [flat|nested] only message in thread