[RFC][PATCH] spidernet: enable fiber autonegotiation

[RFC][PATCH] spidernet: enable fiber autonegotiation

[Jens Osterkamp]

While experimenting with a copper passthrough module in bladecenter I found 
out that this needs autonegotiation enabled in order to work properly.
This quick hack enables it with the sideeffect of breaking other bladecenter 
switch configurations.
If anyone has any suggestions or has experimented with the same configuration, 
feel free to comment.

This patch is not meant for inclusion into mainline.

Signed-off-by: Jens Osterkamp <jens@de.ibm.com>

Index: linux-2.6.19-rc6/drivers/net/spider_net.c
===================================================================
--- linux-2.6.19-rc6.orig/drivers/net/spider_net.c
+++ linux-2.6.19-rc6/drivers/net/spider_net.c
@@ -1724,8 +1724,10 @@ spider_net_setup_phy(struct spider_net_c
  phy->mdio_read = spider_net_read_phy;
  phy->mdio_write = spider_net_write_phy;
 
+ /* reset phy, read id and setup phy struct with phy ops*/
  mii_phy_probe(phy, phy->mii_id);
 
+ /* write fix speed and duplex to BMCR */
  if (phy->def->ops->setup_forced)
   phy->def->ops->setup_forced(phy, SPEED_1000, DUPLEX_FULL);
 
Index: linux-2.6.19-rc6/drivers/net/sungem_phy.c
===================================================================
--- linux-2.6.19-rc6.orig/drivers/net/sungem_phy.c
+++ linux-2.6.19-rc6/drivers/net/sungem_phy.c
@@ -335,10 +335,6 @@ static int bcm5421_enable_fiber(struct m
  /* LEDs active in both modes, autosense prio = fiber */
  phy_write(phy, MII_NCONFIG, 0x945f);
 
- /* switch off fibre autoneg */
- phy_write(phy, MII_NCONFIG, 0xfc01);
- phy_write(phy, 0x0b, 0x0004);
-
  return 0;
 }
 
@@ -347,7 +343,7 @@ static int bcm5461_enable_fiber(struct m
  phy_write(phy, MII_NCONFIG, 0xfc0c);
  phy_write(phy, MII_BMCR, 0x4140);
  phy_write(phy, MII_NCONFIG, 0xfc0b);
- phy_write(phy, MII_BMCR, 0x0140);
+ phy_write(phy, MII_BMCR, 0x1140);
 
  return 0;
 }

Re: [RFC][PATCH] spidernet: enable fiber autonegotiation

[Jens Osterkamp]

>   On my Cell blade this failed on the latest build (be0646). Running with
> the changes to sungem_phy does not allow the interfaces to ping anything.
> I went back to the original and everything works again. All I did was
> change sungem_phy and force it to be reloaded, let me know if I missed a
> step somewhere.

As I stated above, this is expected behaviour :

"This quick hack enables it with the sideeffect of breaking other bladecenter
switch configurations."

Jens