[PATCH v4 8/9] pasemi_mac: PHY support

[Olof Johansson <olof@lixom.net>]

[-- Attachment #1: n-9 --]
[-- Type: text/plain, Size: 5482 bytes --]

PHY support for pasemi_mac.

Signed-off-by: Olof Johansson <olof@lixom.net>


Index: netdev-2.6/drivers/net/pasemi_mac.c
===================================================================
--- netdev-2.6.orig/drivers/net/pasemi_mac.c
+++ netdev-2.6/drivers/net/pasemi_mac.c
@@ -606,6 +606,114 @@ static irqreturn_t pasemi_mac_tx_intr(in
 	return IRQ_HANDLED;
 }
 
+static void pasemi_adjust_link(struct net_device *dev)
+{
+	struct pasemi_mac *mac = netdev_priv(dev);
+	int msg;
+	unsigned int flags;
+	unsigned int new_flags;
+
+	if (!mac->phydev->link) {
+		/* If no link, MAC speed settings don't matter. Just report
+		 * link down and return.
+		 */
+		if (mac->link && netif_msg_link(mac))
+			printk(KERN_INFO "%s: Link is down.\n", dev->name);
+
+		netif_carrier_off(dev);
+		mac->link = 0;
+
+		return;
+	} else
+		netif_carrier_on(dev);
+
+	pci_read_config_dword(mac->pdev, PAS_MAC_CFG_PCFG, &flags);
+	new_flags = flags & ~(PAS_MAC_CFG_PCFG_HD | PAS_MAC_CFG_PCFG_SPD_M |
+			      PAS_MAC_CFG_PCFG_TSR_M);
+
+	if (!mac->phydev->duplex)
+		new_flags |= PAS_MAC_CFG_PCFG_HD;
+
+	switch (mac->phydev->speed) {
+	case 1000:
+		new_flags |= PAS_MAC_CFG_PCFG_SPD_1G |
+			     PAS_MAC_CFG_PCFG_TSR_1G;
+		break;
+	case 100:
+		new_flags |= PAS_MAC_CFG_PCFG_SPD_100M |
+			     PAS_MAC_CFG_PCFG_TSR_100M;
+		break;
+	case 10:
+		new_flags |= PAS_MAC_CFG_PCFG_SPD_10M |
+			     PAS_MAC_CFG_PCFG_TSR_10M;
+		break;
+	default:
+		printk("Unsupported speed %d\n", mac->phydev->speed);
+	}
+
+	/* Print on link or speed/duplex change */
+	msg = mac->link != mac->phydev->link || flags != new_flags;
+
+	mac->duplex = mac->phydev->duplex;
+	mac->speed = mac->phydev->speed;
+	mac->link = mac->phydev->link;
+
+	if (new_flags != flags)
+		pci_write_config_dword(mac->pdev, PAS_MAC_CFG_PCFG, new_flags);
+
+	if (msg && netif_msg_link(mac))
+		printk(KERN_INFO "%s: Link is up at %d Mbps, %s duplex.\n",
+		       dev->name, mac->speed, mac->duplex ? "full" : "half");
+}
+
+static int pasemi_mac_phy_init(struct net_device *dev)
+{
+	struct pasemi_mac *mac = netdev_priv(dev);
+	struct device_node *dn, *phy_dn;
+	struct phy_device *phydev;
+	unsigned int phy_id;
+	const phandle *ph;
+	const unsigned int *prop;
+	struct resource r;
+	int ret;
+
+	dn = pci_device_to_OF_node(mac->pdev);
+	ph = get_property(dn, "phy-handle", NULL);
+	if (!ph)
+		return -ENODEV;
+	phy_dn = of_find_node_by_phandle(*ph);
+
+	prop = get_property(phy_dn, "reg", NULL);
+	ret = of_address_to_resource(phy_dn->parent, 0, &r);
+	if (ret)
+		goto err;
+
+	phy_id = *prop;
+	snprintf(mac->phy_id, BUS_ID_SIZE, PHY_ID_FMT, (int)r.start, phy_id);
+
+	of_node_put(phy_dn);
+
+	mac->link = 0;
+	mac->speed = 0;
+	mac->duplex = -1;
+
+	phydev = phy_connect(dev, mac->phy_id, &pasemi_adjust_link, 0, PHY_INTERFACE_MODE_SGMII);
+
+	if (IS_ERR(phydev)) {
+		printk(KERN_ERR "%s: Could not attach to phy\n", dev->name);
+		return PTR_ERR(phydev);
+	}
+
+	mac->phydev = phydev;
+
+	return 0;
+
+err:
+	of_node_put(phy_dn);
+	return -ENODEV;
+}
+
+
 static int pasemi_mac_open(struct net_device *dev)
 {
 	struct pasemi_mac *mac = netdev_priv(dev);
@@ -678,6 +786,13 @@ static int pasemi_mac_open(struct net_de
 
 	pasemi_mac_replenish_rx_ring(dev);
 
+	ret = pasemi_mac_phy_init(dev);
+	/* Some configs don't have PHYs (XAUI etc), so don't complain about
+	 * failed init due to -ENODEV.
+	 */
+	if (ret && ret != -ENODEV)
+		dev_warn(&mac->pdev->dev, "phy init failed: %d\n", ret);
+
 	netif_start_queue(dev);
 	netif_poll_enable(dev);
 
@@ -708,6 +823,9 @@ static int pasemi_mac_open(struct net_de
 		goto out_rx_int;
 	}
 
+	if (mac->phydev)
+		phy_start(mac->phydev);
+
 	return 0;
 
 out_rx_int:
@@ -731,6 +849,11 @@ static int pasemi_mac_close(struct net_d
 	unsigned int stat;
 	int retries;
 
+	if (mac->phydev) {
+		phy_stop(mac->phydev);
+		phy_disconnect(mac->phydev);
+	}
+
 	netif_stop_queue(dev);
 
 	/* Clean out any pending buffers */
@@ -1032,6 +1155,9 @@ pasemi_mac_probe(struct pci_dev *pdev, c
 	else
 		mac->msg_enable = pasemi_mac_debug;
 
+	/* Enable most messages by default */
+	mac->msg_enable = (NETIF_MSG_IFUP << 1 ) - 1;
+
 	err = register_netdev(dev);
 
 	if (err) {
Index: netdev-2.6/drivers/net/pasemi_mac.h
===================================================================
--- netdev-2.6.orig/drivers/net/pasemi_mac.h
+++ netdev-2.6/drivers/net/pasemi_mac.h
@@ -24,6 +24,7 @@
 #include <linux/ethtool.h>
 #include <linux/netdevice.h>
 #include <linux/spinlock.h>
+#include <linux/phy.h>
 
 struct pasemi_mac_txring {
 	spinlock_t	 lock;
@@ -54,6 +55,7 @@ struct pasemi_mac {
 	struct pci_dev *pdev;
 	struct pci_dev *dma_pdev;
 	struct pci_dev *iob_pdev;
+	struct phy_device *phydev;
 	struct net_device_stats stats;
 
 	/* Pointer to the cacheable per-channel status registers */
@@ -75,8 +77,12 @@ struct pasemi_mac {
 	struct pasemi_mac_rxring *rx;
 	unsigned long	tx_irq;
 	unsigned long	rx_irq;
+	int	link;
+	int	speed;
+	int	duplex;
 
 	unsigned int	msg_enable;
+	char	phy_id[BUS_ID_SIZE];
 };
 
 /* Software status descriptor (desc_info) */
Index: netdev-2.6/drivers/net/Kconfig
===================================================================
--- netdev-2.6.orig/drivers/net/Kconfig
+++ netdev-2.6/drivers/net/Kconfig
@@ -2488,6 +2488,7 @@ config NETXEN_NIC
 config PASEMI_MAC
 	tristate "PA Semi 1/10Gbit MAC"
 	depends on PPC64 && PCI
+	select PHYLIB
 	help
 	  This driver supports the on-chip 1/10Gbit Ethernet controller on
 	  PA Semi's PWRficient line of chips.

--