From: linas@austin.ibm.com (Linas Vepstas)
To: Jeff Garzik <jeff@garzik.org>
Cc: Michael Ellerman <michael@ellerman.id.au>,
netdev@vger.kernel.org, cbe-oss-dev@ozlabs.org
Subject: [PATCH] spidernet: Replace literal with const
Date: Thu, 14 Jun 2007 18:12:23 -0500 [thread overview]
Message-ID: <20070614231223.GZ4397@austin.ibm.com> (raw)
In-Reply-To: <46704F90.7050508@garzik.org>
Replace literal with const; add bit definitions.
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
----
On Wed, Jun 13, 2007 at 04:12:00PM -0400, Jeff Garzik wrote:
> A follow-up patch needs to remove the above magic numbers (==numeric
> constants), replacing them with named constants
Here it is. Lightly stres-tested (about 1/2 hour), as this patch
tests some additonal bits.
drivers/net/spider_net.c | 2 +-
drivers/net/spider_net.h | 19 +++++++++++++++++++
2 files changed, 20 insertions(+), 1 deletion(-)
Index: linux-2.6.22-rc1/drivers/net/spider_net.c
===================================================================
--- linux-2.6.22-rc1.orig/drivers/net/spider_net.c 2007-06-11 15:39:03.000000000 -0500
+++ linux-2.6.22-rc1/drivers/net/spider_net.c 2007-06-14 17:23:32.000000000 -0500
@@ -1235,7 +1235,7 @@ spider_net_decode_one_descr(struct spide
goto bad_desc;
}
- if (hwdescr->dmac_cmd_status & 0xfcf4) {
+ if (hwdescr->dmac_cmd_status & SPIDER_NET_DESCR_BAD_STATUS) {
dev_err(&card->netdev->dev, "bad status, cmd_status=x%08x\n",
hwdescr->dmac_cmd_status);
pr_err("buf_addr=x%08x\n", hw_buf_addr);
Index: linux-2.6.22-rc1/drivers/net/spider_net.h
===================================================================
--- linux-2.6.22-rc1.orig/drivers/net/spider_net.h 2007-06-11 15:39:03.000000000 -0500
+++ linux-2.6.22-rc1/drivers/net/spider_net.h 2007-06-14 17:34:56.000000000 -0500
@@ -359,6 +359,18 @@ enum spider_net_int2_status {
#define SPIDER_NET_DMAC_UDP 0x00030000
#define SPIDER_NET_TXDCEST 0x08000000
+#define SPIDER_NET_DESCR_RXFDIS 0x00000001
+#define SPIDER_NET_DESCR_RXDCEIS 0x00000002
+#define SPIDER_NET_DESCR_RXDEN0IS 0x00000004
+#define SPIDER_NET_DESCR_RXINVDIS 0x00000008
+#define SPIDER_NET_DESCR_RXRERRIS 0x00000010
+#define SPIDER_NET_DESCR_RXFDCIMS 0x00000100
+#define SPIDER_NET_DESCR_RXDCEIMS 0x00000200
+#define SPIDER_NET_DESCR_RXDEN0IMS 0x00000400
+#define SPIDER_NET_DESCR_RXINVDIMS 0x00000800
+#define SPIDER_NET_DESCR_RXRERRMIS 0x00001000
+#define SPIDER_NET_DESCR_UNUSED 0x077fe0e0
+
#define SPIDER_NET_DESCR_IND_PROC_MASK 0xF0000000
#define SPIDER_NET_DESCR_COMPLETE 0x00000000 /* used in rx and tx */
#define SPIDER_NET_DESCR_RESPONSE_ERROR 0x10000000 /* used in rx and tx */
@@ -369,6 +381,13 @@ enum spider_net_int2_status {
#define SPIDER_NET_DESCR_NOT_IN_USE 0xF0000000
#define SPIDER_NET_DESCR_TXDESFLG 0x00800000
+#define SPIDER_NET_DESCR_BAD_STATUS (SPIDER_NET_DESCR_RXDEN0IS | \
+ SPIDER_NET_DESCR_RXRERRIS | \
+ SPIDER_NET_DESCR_RXDEN0IMS | \
+ SPIDER_NET_DESCR_RXINVDIMS | \
+ SPIDER_NET_DESCR_RXRERRMIS | \
+ SPIDER_NET_DESCR_UNUSED)
+
/* Descriptor, as defined by the hardware */
struct spider_net_hw_descr {
u32 buf_addr;
next prev parent reply other threads:[~2007-06-14 23:12 UTC|newest]
Thread overview: 69+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-06-07 19:17 [PATCH 0/18] spidernet driver bug fixes Linas Vepstas
2007-06-07 19:20 ` [PATCH 1/18] spidernet: skb used after netif_receive_skb Linas Vepstas
2007-06-07 19:22 ` [PATCH 2/18] spidernet: checksum and ethtool Linas Vepstas
2007-06-07 19:24 ` [PATCH 3/18] spidernet: beautify error messages Linas Vepstas
2007-06-07 19:25 ` [PATCH 4/18] spidernet: move a block of code around Linas Vepstas
2007-06-07 19:27 ` [PATCH 5/18] spidernet: zero out a pointer Linas Vepstas
2007-06-07 19:29 ` [PATCH 6/18] spidernet: null out skb pointer after its been used Linas Vepstas
2007-06-07 19:33 ` [PATCH 7/18] spidernet: Don't terminate the RX ring Linas Vepstas
2007-06-07 19:35 ` [PATCH 8/18] spidernet: enhance the dump routine Linas Vepstas
2007-06-07 19:39 ` [PATCH 9/18] spidernet: reset the card when an rxramfull is seen Linas Vepstas
2007-06-07 19:41 ` [PATCH 10/18] spidernet: service TX later Linas Vepstas
2007-06-07 19:43 ` [PATCH 11/18] spidernet: increase the NAPI weight Linas Vepstas
2007-06-07 19:45 ` [PATCH 12/18] spidernet: don't flag rare packets as bad packets Linas Vepstas
2007-06-07 19:51 ` [PATCH 13/18] spidernet: Cure RX ram full bug Linas Vepstas
2007-06-07 19:53 ` [PATCH 14/18] spidernet: silence the ramfull messages Linas Vepstas
2007-06-07 19:55 ` [PATCH 15/18] spidernet: minor RX optimization Linas Vepstas
2007-06-07 19:57 ` [PATCH 16/18] spidernet: fix misnamed flag Linas Vepstas
2007-06-07 20:01 ` [PATCH 17/18] spidernet: turn off descriptor chain end interrupt Linas Vepstas
2007-06-07 20:05 ` [PATCH 18/18] spidernet: driver docmentation Linas Vepstas
2007-06-08 1:12 ` [Cbe-oss-dev] [PATCH 0/18] spidernet driver bug fixes Michael Ellerman
2007-06-08 17:06 ` Linas Vepstas
2007-06-08 17:20 ` Jeff Garzik
2007-06-11 18:14 ` [PATCH 0/15] " Linas Vepstas
2007-06-11 18:17 ` [PATCH 1/15] spidernet: null out skb pointer after its been used Linas Vepstas
2007-06-11 18:21 ` [PATCH 2/15] spidernet: Cure RX ram full bug Linas Vepstas
2007-06-11 18:23 ` [PATCH 3/15] spidernet: Don't terminate the RX ring Linas Vepstas
2007-06-11 18:26 ` [PATCH 4/15] spidernet: silence the ramfull messages Linas Vepstas
2007-06-13 20:12 ` Jeff Garzik
2007-06-14 22:29 ` Linas Vepstas
2007-06-14 23:12 ` Linas Vepstas [this message]
2007-07-02 12:37 ` [PATCH] spidernet: Replace literal with const Jeff Garzik
2007-06-11 18:29 ` [PATCH 5/15] spidernet: turn off descriptor chain end interrupt Linas Vepstas
2007-06-11 18:32 ` [PATCH 6/15] spidernet: skb used after netif_receive_skb Linas Vepstas
2007-06-11 18:35 ` [PATCH 7/15] spidernet: checksum and ethtool Linas Vepstas
2007-06-11 18:41 ` [PATCH 8/15] spidernet: beautify error messages Linas Vepstas
2007-06-13 20:15 ` Jeff Garzik
2007-06-11 18:48 ` [PATCH 9/15] spidernet: enhance the dump routine Linas Vepstas
2007-06-11 18:52 ` [PATCH 10/15] spidernet: invalidate unused pointer Linas Vepstas
2007-06-11 18:59 ` [PATCH 11/15] spidernet: service TX later Linas Vepstas
2007-06-11 19:02 ` [PATCH 12/15] spidernet: increase the NAPI weight Linas Vepstas
2007-06-13 20:14 ` Jeff Garzik
2007-06-13 20:49 ` [Cbe-oss-dev] " Arnd Bergmann
2007-06-14 22:08 ` Linas Vepstas
2007-06-11 19:05 ` [PATCH 13/15] spidernet: move a block of code around Linas Vepstas
2007-06-11 19:09 ` [PATCH 14/15] spidernet: fix misnamed flag Linas Vepstas
2007-06-11 19:12 ` [PATCH 15/15] spidernet: driver docmentation Linas Vepstas
2007-06-13 20:10 ` [PATCH 1/15] spidernet: null out skb pointer after its been used Jeff Garzik
2007-06-14 22:00 ` Linas Vepstas
2007-06-12 2:01 ` [PATCH 0/15] spidernet driver bug fixes Michael Ellerman
2007-06-12 23:00 ` Jeff Garzik
2007-06-12 23:32 ` Linas Vepstas
2007-06-13 0:04 ` Jeff Garzik
2007-06-13 16:14 ` Linas Vepstas
2007-06-13 18:51 ` Jeff Garzik
2007-06-13 19:01 ` [Cbe-oss-dev] " Segher Boessenkool
2007-06-13 19:02 ` Jeff Garzik
2007-06-13 20:52 ` Arnd Bergmann
2007-06-13 23:55 ` Michael Ellerman
2007-06-13 18:52 ` Jeff Garzik
2007-06-14 22:08 ` [Cbe-oss-dev] " David Woodhouse
2007-06-14 23:01 ` Jeff Garzik
2007-06-14 23:03 ` David Woodhouse
2007-06-14 23:04 ` Jeff Garzik
2007-06-14 23:07 ` David Woodhouse
2007-06-14 23:32 ` Michael Ellerman
2007-06-13 1:33 ` Michael Ellerman
2007-06-13 1:54 ` Jeff Garzik
2007-06-13 13:53 ` Michael Ellerman
2007-06-13 18:45 ` Jeff Garzik
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20070614231223.GZ4397@austin.ibm.com \
--to=linas@austin.ibm.com \
--cc=cbe-oss-dev@ozlabs.org \
--cc=jeff@garzik.org \
--cc=michael@ellerman.id.au \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).